Hello,

I did a current VAX build -- the host was x86.  I booted and installed
the iso-image booted on a simh VAX.  It appeared to work okay.  Now I
booted the simh VAX, off the MSCP drive.

I got this scrolling on the console, after "Building databases...":
    dev_mkdb in free(): warning: page is already free.
    dev_mkdb in free(): warning: chunk is already free.
    dev_mkdb in free(): warning: page is already free.
    dev_mkdb in free(): warning: chunk is already free.
    dev_mkdb in free(): warning: page is already free.
    dev_mkdb in free(): warning: chunk is already free.
    dev_mkdb in free(): warning: page is already free.
    dev_mkdb in free(): warning: chunk is already free.
    dev_mkdb in free(): warning: page is already free.


>> NetBSD/vax boot [1.11 Sat Jun  3 14:36:36 EDT 2006] <<
>> Press any key to abort autoboot 0
nfs_open: must mount first.
open netbsd.vax: Device not configured
> boot netbsd
1935144+168608 [178048+163575]=0x25536c
Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006
    The NetBSD Foundation, Inc.  All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
    The Regents of the University of California.  All rights reserved.

NetBSD 3.99.20 (GENERIC) #0: Sat Jun  3 14:53:27 EDT 2006
    kirk@greyhawk:/bstg/current/vax/obj/sys/arch/vax/compile/GENERIC
MicroVAX 3800/3900
cpu: KA655, CVAX microcode rev 6 Firmware rev 83
total memory = 32708 KB
avail memory = 29024 KB
mainbus0 (root)
ibus0 at mainbus0
uba0 at ibus0: Q22
dz1 at uba0 csr 160100 vec 304 ipl 15
uda0 at uba0 csr 172150 vec 774 ipl 15
mscpbus0 at uda0: version 3 model 3
mscpbus0: DMA burst size set to 4
ra0 at mscpbus0 drive 0: RA92
ra1 at mscpbus0 drive 1: RA92
ra2 at mscpbus0 drive 2: RRD40
rx0 at mscpbus0 drive 3: RX50
Kernelized RAIDframe activated
ra0: size 2940951 sectors
ra1: no disk label: size 2940951 sectors
ra2: no disk label: size 1331200 sectors
boot device: ra0
root on ra0a dumps on ra0b
root file system type: ffs
Fri Jun  2 18:45:14 UTC 2006
swapctl: adding /dev/ra0b as swap device at priority 0
Checking for botched superblock upgrades: done.
Starting file system checks:
/dev/rra0a: file system is clean; not checking
Setting tty flags.
Setting sysctl variables:
Starting network.
/etc/rc: WARNING: $hostname not set.
IPv6 mode: host
Configuring network interfaces:.
Adding interface aliases:
Building databases...
dev_mkdb in free(): warning: page is already free.
dev_mkdb in free(): warning: chunk is already free.
dev_mkdb in free(): warning: page is already free.
dev_mkdb in free(): warning: chunk is already free.


-- 
Kirk Russell            <kirk@ba23.org>            http://www.ba23.org/
Bridlewood Software Testers Guild                  Ottawa Ontario Canada