msk(4) problems (was: Looking for Core 2 Duo mainboard suggestions)

[Bernd Ernesti <netbsd%lists.veego.de@localhost>]

On Wed, Jan 07, 2009 at 01:14:15PM +0200, Mihai Chelaru wrote:
[..]
> Here is the dmesg from Asus P5Q-E (is this the Deluxe one ?) equipped 
> with Q9300 (quad-core). Everything's fine except the msk0 card that 
> sometimes just stops working and I have to ifconfig down up it. Although 
> it is better with NetBSD than with Windows where using this NIC entirely 
> freezes the system after a while. But it has a second NIC integrated 
> that I use without problems.

I have the same problem with a msk and an AMD 790GX board.

[..]
> pci4 at ppb3 bus 2
> pci4: i/o space, memory space enabled, rd/line, wr/inv ok
> mskc0 at pci4 dev 0 function 0mskc0: interrupt moderation is 0 us
> , Yukon-2 EC Ultra rev. B0 (0x3): ioapic0 pin 17
> msk0 at mskc0 port A: Ethernet address 00:22:15:80:9f:02
> ukphy0 at msk0 phy 0: Generic IEEE 802.3u media interface
> ukphy0: OUI 0x000ac2, model 0x000b, rev. 1
> ukphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT, 
> 1000baseT-FDX, auto

pci2 at ppb1 bus 2
pci2: i/o space, memory space enabled, rd/line, wr/inv ok
mskc0 at pci2 dev 0 function 0mskc0: interrupt moderation is 0 us
, Yukon-2 EC Ultra rev. B0 (0x3): ioapic0 pin 18
msk0 at mskc0 port A: Ethernet address 00:22:15:xx:xx:xx
ukphy0 at msk0 phy 0: Generic IEEE 802.3u media interface
ukphy0: OUI 0x000ac2, model 0x000b, rev. 1
ukphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT, 
1000baseT-FDX, auto

So the same chip with ukphy too.

Bernd