Re: sata controller

["Malcolm Herbert" <mjch%mjch.net@localhost>]

I did some googling and found some messages on a FreeBSD list from 2006
which mentioned the same part number and asking about support ... didn't
follow that to see whether they'd completed it, so I might look into
that ... 

Regards,
Malcolm

On Mon, 29 Nov 2010 17:16 +0100, "Manuel Bouyer"
<bouyer%antioche.eu.org@localhost> wrote:
> On Mon, Nov 29, 2010 at 11:16:05PM +1100, Malcolm Herbert wrote:
> > I've recently added a Sunix SATA controller to one of my embedded hosts
> > however the installed GENERIC 5.0.1 kernel didn't recognise the card ... 
> > 
> > not too worried by that, but does anyone know if the following is
> > available in -current?
> > 
> > vendor 0x1101 product 0x1622 (SATA mass storage, revision 0x02) at pci0
> > dev 14 function 0 not configured
> > 
> > It is billed as a 'SATA 150 RAID PCI' card, although I'm not that
> > interested in the RAID functionality.  There are two main chips on there
> > - initio INIC-1622TA2 and an EON EN29LV010-70JCP
> 
> It's probably this controller:
> http://www.initio.com/Html/inic-1620.html
> 
> if someone can find a programming manual it's probably not too hard to
> write a driver.
> 
> -- 
> Manuel Bouyer <bouyer%antioche.eu.org@localhost>
>      NetBSD: 26 ans d'experience feront toujours la difference
> --
> 

-- 
Malcolm Herbert                                This brain intentionally
mjch%mjch.net@localhost                                                left 
blank