Re: Bebox hardware question

[John Franklin <franklin%elfie.org@localhost>]

On Tue, Nov 21, 2000 at 10:39:30PM +0000, Jim Frankel wrote:
> Hello all,
>      I have a rediculous question that I suspect no one can help me with, 
> but I have to ask, so here it goes.
>      I have a bebox motherboard without the I/O daughter board.  I would 
> like to plug a mouse into my system.  The mouse port is/was on the daughter 
> board.  This is a problem.
[snip]
>      Any help would be appreciated.

Those had PCI slots, IIRC.  Would getting a USB PCI card and a USB mouse
be an acceptable solution?  Since USB is supported under macppc, the
code should "just work" with the BeBox.

jf
-- 
John Franklin
franklin%elfie.org@localhost
ICBM: 35°48'19"N 78°46'39"W