"Matias Romeo" <mromeo@ingdesi.net> writes:

> I have the following problem. My box has 2 nics , one is PCI and the other
> one is ISA .
> 
> DE-220CT ==> ISA
> EPIC          ==> PCI
> 
> When i boot my PC the kernel-debuger shows ( after the kernel recogize both
> nics using same interrupt ) saying "cannot share level triggered interupt
> with edge triggered interrupt  ... . . ..  ." .

You need to prevent the ISA and PCI devices from sharing an
interrupt. If you go into the BIOS setup menus when booting your
system, the BIOS should have a way to specify which interrupts to use
for PCI. You should make sure that that set does not include the
interrupt used by your ISA device, apparantly IRQ 10.

> After this message i boot my PC with a DOS-boot floppy and used the DE-220
> configuration program to change the interrupt , but i have the same problem
> even if i change the interrupt number to 9/5/14/15 etc,etc.
> The ISA nic is always using interrupt 10.

This seems kind of suspicious, though, if you can't change the IRQ the
device is using.

How exactly does the DE-220CT probe? Is it possible to take the EPIC
card out long enough to boot successfully and use the card?

        - Nathan