On Thu, May 16, 2002 at 09:22:15PM +0200, Manuel Bouyer wrote:
> On Thu, May 16, 2002 at 10:42:25AM +0300, Martti Kuparinen wrote:
> > Hi!
> > 
> > I just made a clean install of 1.5ZC and the installation itself went fine.
> > The first reboot failed (or froze my PC) with the GENERIC kernel after
> > detecting the AGP.
> > 
> > The solution to my problem was to create a custon kernel without
> > "agp* at pchb?", boot from the floppies, mount /dev/wd0a /mnt and ftp the
> > new kernel to the harddisk.
> > 
> > Anyone else noticed problems with "agp*  at pchb?". My PC is HP Omnibook
> > 4150 with the latest BIOS. My other PCs (home, work, server, firewalls)
> 
> What chipset does it have ? can you post dmesg ?

I have exactly the same problem on my Acer TravelMate 350TE.  My laptop
has a BIOS setting to set aside up to 8MB of the available memory for the
video memory.  My dmesg with a kernel built without "agp* at pchb?" is
included below.

	Cheers,

	-- Johnny Lam <jlam@netbsd.org>

NetBSD 1.5ZC (LAZARUS) #0: Thu May  9 22:41:44 EDT 2002
    jlam@lazarus.home.net:/usr/obj/sys/arch/i386/compile/LAZARUS
cpu0: Intel Pentium III (Coppermine) (686-class), 647.67 MHz
cpu0: I-cache 16 KB 32b/line 4-way, D-cache 16 KB 32b/line 2-way
cpu0: L2 cache 256 KB 32b/line 8-way
cpu0: features 383f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR>
cpu0: features 383f9ff<PGE,MCA,CMOV,FGPAT,PSE36,MMX>
cpu0: features 383f9ff<FXSR,SSE>
total memory = 311 MB
avail memory = 283 MB
using 4013 buffers containing 16052 KB of memory
BIOS32 rev. 0 found at 0xf0210
PCI BIOS rev. 2.1 found at 0xf0200
PCI IRQ Routing Table rev. 1.0 found at 0xfb9d0, size 176 bytes (9 entries)
PCI Interrupt Router at 255:31:7
pci_addr_fixup: 000:19:0 0x1217 0x6933 new address 0x13800000
pci_addr_fixup: 000:19:1 0x1217 0x6933 new address 0x13801000
mainbus0 (root)
pnpbios0 at mainbus0: code fa000, data f0000, entry 0, control 1 eventp 4b0
pnpbios0: nodes 15, max len 158
PNP0A03 (io cf8-cff 4d0-4d1) at pnpbios0 index 0 ignored
PNP0000 (io 20-21 a0-a1, irq 2) at pnpbios0 index 1 ignored
PNP0200 (io 0-f 81-8f c0-df 40b 480-48f 4d6, dma 4) at pnpbios0 index 2 ignored
PNP0100 (io 40-43, irq 0) at pnpbios0 index 3 ignored
PNP0B00 (io 70-73, irq 8) at pnpbios0 index 4 ignored
PNP0800 (io 61) at pnpbios0 index 5 ignored
PNP0C04 (io f0-ff, irq 13) at pnpbios0 index 6 ignored
PNP0C01 (mem 0-9ffff f0000-fffff ffff0000-ffffffff) at pnpbios0 index 7 ignored
PNP0C02 (mem 100000-ffffff 1000000-137fffff, io 22 1060-106f f100-f13f f140-f15f 80 92) at pnpbios0 index 8 ignored
pckbc0 at pnpbios0 index 9 (PNP0303): kbd port
pckbc1 at pnpbios0 index 11 (PNP0F13): aux port
PNP0401 (io 378-37f 778-77b, irq 7, dma 1) at pnpbios0 index 13 ignored
com0 at pnpbios0 index 14 (PNP0501)
com0: io 3f8-3ff, irq 4
com0: ns16550a, working fifo
com1 at pnpbios0 index 15 (ALI5123, attached as PNP0511)
com1: io 2f8-2ff, irq 3, dma 3
com1: ns16550a, working fifo
PNP0700 (io 3f0-3f5 3f7, irq 6, dma 2) at pnpbios0 index 16 ignored
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard
pms0 at pckbc0 (aux slot)
pckbc0: using irq 12 for aux slot
wsmouse0 at pms0 mux 0
pci0 at mainbus0 bus 0: configuration mode 1
pci0: i/o space, memory space enabled, rd/line, rd/mult, wr/inv ok
pchb0 at pci0 dev 0 function 0
pchb0: Acer Labs product 0x1621 (rev. 0x01)
agp at pchb0 not configured
ppb0 at pci0 dev 1 function 0: Acer Labs product 0x5247 (rev. 0x01)
pci1 at ppb0 bus 1
pci1: i/o space, memory space enabled
vga0 at pci1 dev 0 function 0: Trident Microsystems product 0x8620 (rev. 0x5d)
wsdisplay0 at vga0 kbdmux 1: console (80x25, vt100 emulation), using wskbd0
wsmux1: connecting to wsdisplay0
autri0 at pci0 dev 6 function 0: Acer Labs M5451 AC-Link Controller Audio Device (rev. 0x01)
autri0: interrupting at irq 10
autri0: Crystal CS4299 codec; headphone, 20 bit DAC, 18 bit ADC, Crystal Semi 3D
audio0 at autri0: full duplex, mmap, independent
midi0 at autri0: 4DWAVE MIDI UART
pcib0 at pci0 dev 7 function 0
pcib0: Acer Labs M1543 PCI-ISA Bridge (rev. 0x00)
fxp0 at pci0 dev 10 function 0: i82559 Ethernet, rev 8
fxp0: interrupting at irq 10
fxp0: Ethernet address 00:d0:59:26:34:a1
inphy0 at fxp0 phy 1: i82555 10/100 media interface, rev. 4
inphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
Texas Instruments TSB43AA22 OHCI IEEE 1394 Host Controller (Firewire serial bus, interface 0x10, revision 0x02) at pci0 dev 11 function 0 not configured
pciide0 at pci0 dev 16 function 0: Acer Labs M5229 UDMA IDE Controller (rev. 0xc3)
pciide0: bus-master DMA support present
pciide0: primary channel configured to compatibility mode
wd0 at pciide0 channel 0 drive 0: <TOSHIBA MK1017GAP>
wd0: drive supports 16-sector PIO transfers, LBA addressing
wd0: 9590 MB, 16383 cyl, 16 head, 63 sec, 512 bytes/sect x 19640880 sectors
wd0: 32-bit data port
wd0: drive supports PIO mode 4, DMA mode 2, Ultra-DMA mode 4 (Ultra/66)
pciide0: primary channel interrupting at irq 14
wd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 2 (Ultra/33) (using DMA data transfers)
pciide0: secondary channel configured to compatibility mode
pciide0: disabling secondary channel (no drives)
Acer Labs M7101 Power Management Controller (miscellaneous bridge) at pci0 dev 17 function 0 not configured
cbb0 at pci0 dev 19 function 0: O2 Micro Inc product 0x6933 (rev. 0x02)
cbb1 at pci0 dev 19 function 1: O2 Micro Inc product 0x6933 (rev. 0x02)
ohci0 at pci0 dev 20 function 0: Acer Labs M5237 USB Host Controller (rev. 0x03)
ohci0: interrupting at irq 11
ohci0: OHCI version 1.0, legacy support
usb0 at ohci0: USB revision 1.0
uhub0 at usb0
uhub0: Acer Labs OHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 3 ports with 3 removable, self powered
isa0 at pcib0
lpt0 at isa0 port 0x378-0x37b irq 7
pcppi0 at isa0 port 0x61
midi1 at pcppi0: PC speaker
spkr0 at pcppi0
sysbeep0 at pcppi0
npx0 at isa0 port 0xf0-0xff: using exception 16
fdc0 at isa0 port 0x3f0-0x3f7 irq 6 drq 2
cbb0: interrupting at irq 11
cardslot0 at cbb0 slot 0 flags 0
cardbus0 at cardslot0: bus 2 device 0
pcmcia0 at cardslot0
cbb1: interrupting at irq 11
cardslot1 at cbb1 slot 1 flags 0
cardbus1 at cardslot1: bus 3 device 0
pcmcia1 at cardslot1
apm0 at mainbus0: Power Management spec V1.2
biomask eb65 netmask ef65 ttymask ffe7
IPsec: Initialized Security Association Processing.
pcmcia1: CIS version PC Card Standard 7.0
pcmcia1: CIS info: O2Micro, SmartCardBus Reader, V1.0
pcmcia1: Manufacturer code 0xffff, product 0x1
pcmcia1: function 0: unspecified, ccr addr 220 mask 1
pcmcia1: function 0, config table entry 1: I/O card; irq mask beb8; iomask 5, iospace 0-1f; memspace 0-ff; io16 irqlevel
O2Micro, SmartCardBus Reader, V1.0 (manufacturer 0xffff, product 0x0001) at pcmcia1,  function 0 not configured
pcmcia0: CIS version PCMCIA 2.0 or 2.1
pcmcia0: CIS info: Cisco Systems, 350 Series Wireless LAN Adapter
pcmcia0: Manufacturer code 0x15f, product 0xa
pcmcia0: function 0: network adapter, ccr addr 3e0 mask 7
pcmcia0: function 0, config table entry 5: I/O card; irq mask ffff; iomask 6, iospace 0-3f; io16 irqlevel
an0 at pcmcia0 function 0: Cisco Systems, 350 Series Wireless LAN Adapter
an0: 802.11 address: 00:07:50:ca:88:a2
boot device: wd0
root on wd0a dumps on wd0b
wsdisplay0: screen 1 added (80x25, vt100 emulation)
wsdisplay0: screen 2 added (80x25, vt100 emulation)
wsdisplay0: screen 3 added (80x25, vt100 emulation)
wsdisplay0: screen 4 added (80x25, vt100 emulation)