:-)

Is there a driver for the eri interface?


Netra T1 200 (UltraSPARC-IIe 500MHz), No Keyboard
OpenBoot 4.0, 256 MB memory installed, Serial #50721538.
Ethernet address 0:3:ba:5:f3:2, Host ID: 8305f302.



Executing last command: boot disk:b                                   
Boot device: /pci@1f,0/pci@1/scsi@8/disk@0,0:b  File and args: 
NetBSD IEEE 1275 Bootblock
..>> NetBSD/sparc64 OpenFirmware Boot, Revision 1.4
>> (mrg@powerofseven.eterna.com.au, Wed Aug 22 07:27:23 EST 2001)
loadfile: reading header
elf64_exec: Booting /pci@1f,0/pci@1/scsi@8/disk@0,0:b/netbsd
4516312@0x1000000+148632@0x1800000+4045672@0x1824498 
symbols @ 0xfef90300 74+298728+157356 start=0x1000000
chain: calling OF_chain(800000, ee10, 1000000, fffc5a80, 18)
[ using 456936 bytes of netbsd ELF symbol table ]
pmap_bootstrap: could not claim physical dseg extension at f4a0000 size 360000
Setting DTLB entry 00000000 01000000 data e0000000 0f800074
Setting DTLB entry 00000000 01800000 data e0000000 0e800076
Setting ITLB entry 00000000 01000000 data e0000000 0f800074
Setting CPUINFO mappings...
Setting TSB pointer 00000000 018b0000
consinit()
setting up stdin
stdin instance = fffb79e0
setting up stdout
stdout instance = fffb7718
stdout package = f007d5f0
console is unknown
Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001
    The NetBSD Foundation, Inc.  All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993           
    The Regents of the University of California.  All rights reserved.
                                                                      
NetBSD 1.5X (GENERIC) #1: Wed Aug 22 22:58:29 EST 2001
    mrg@powerofseven.eterna.com.au:/orb/a/obj.sparc64/usr/src/sys/arch/sparc64/compile/GENERIC
total memory = 256 MB
avail memory = 223 MB
using 1651 buffers containing 13208 KB of memory
bootpath: /pci@1f,0/pci@1,0/scsi@8,0/disk@0,0:b 
mainbus0 (root): SUNW,UltraAX-i2               
cpu0 at mainbus0: SUNW,UltraSPARC-IIe @ 500 MHz, version 0 FPU
cpu0: physical 4K instruction (32 b/l), 4K data (32 b/l), 8192K external (64 b/l) 
psycho0 at mainbus0
SUNW,sabre: impl 0, version 0: ign 7c0 bus range 0 to 2; PCI bus 0
intr_establish: intr reused 7c0                                   
DVMA map: c0000000 to e0000000 
pci0 at psycho0               
pci0: i/o space, memory space enabled
ppb0 at pci0 dev 1 function 1: Sun Microsystems Simba PCI bridge (rev. 0x13)
pci1 at ppb0 bus 1                                                          
pci1: i/o space, memory space enabled
Sun Microsystems PCIO Ebus2 (US III) (miscellaneous bridge, revision 0x01) at pci1 dev 12 function 0 not configured
Sun Microsystems ERI Ethernet (ethernet network, revision 0x01) at pci1 dev 12 function 1 not configured
Sun Microsystems USB controller (USB serial bus, interface 0x10, revision 0x01) at pci1 dev 12 function 3 not configured
Acer Labs M7101 Power Management Controller (miscellaneous prehistoric) at pci1 dev 3 function 0 not configured
Acer Labs M7101 Power Management Controller (miscellaneous prehistoric) at pci1 dev 3 function 0 not configured
ebus0 at pci1 dev 7 function 0 
ebus0: Acer Labs M1543 PCI-ISA Bridge, revision 0x00
power at ebus0 addr 2000-2007 ipl 37 not configured 
com0 at ebus0 addr 3f8-3ff ipl 43: ns16550a, working fifo
com0: console                                            
com1 at ebus0 addr 2e8-2ef ipl 43intr_establish: intr reused 7eb
: ns16550a, working fifo                                        
pciide0 at pci1 dev 13 function 0: Acer Labs M5229 UDMA IDE Controller (rev. 0xc3)
pciide0: bus-master DMA support present
pciide0: primary channel configured to native-PCI mode
OF_mapintr failed                                     
pciide0: using ivec 180c for native-PCI interrupt
pciide0: disabling primary channel (no drives)   
pciide0: secondary channel configured to native-PCI mode
pciide0: disabling secondary channel (no drives)        
pci_conf_read: bogus pcitag 12800               
ppb1 at pci0 dev 1 function 0: Sun Microsystems Simba PCI bridge (rev. 0x13)
pci2 at ppb1 bus 2                                                          
pci2: i/o space, memory space enabled
siop0 at pci2 dev 8 function 0: Symbios Logic 53c896 (ultra2-wide scsi)
siop0: using on-board RAM                                              
OF_mapintr failed        
siop0: interrupting at ivec 20
scsibus0 at siop0: 16 targets, 8 luns per target
siop1 at pci2 dev 8 function 1: Symbios Logic 53c896 (ultra2-wide scsi)
siop1: using on-board RAM                                              
OF_mapintr failed        
intr_establish: intr reused 7e0
siop1: interrupting at ivec 20 
scsibus1 at siop1: 16 targets, 8 luns per target
pcons at mainbus0 not configured                
No counter-timer -- using %tick at 500MHz as system clock.
Using %tick -- intr in 5000000 cycles...done.             
scsibus0: waiting 2 seconds for devices to settle...
siop0: alloc newcdb at PHY addr 0xc0000000          
sd0 at scsibus0 target 0 lun 0: <SEAGATE, ST318404LSUN18G, 4203> SCSI3 0/direct fixed
sd0: 17274 MB, 7508 cyl, 19 head, 248 sec, 512 bytes/sect x 35378533 sectors
sd0: sync (25.0ns offset 31), 16-bit (80.000MB/s) transfers, tagged queueing
scsibus1: waiting 2 seconds for devices to settle...                        
siop1: alloc newcdb at PHY addr 0xc0002000          
raidattach: Asked for 4 units             
Kernelized RAIDframe activated
root device: sd0b             
dump device (default sd0b): 
file system (default generic): 
root on sd0b dumps on sd0b     
mountroot: trying msdos...
mountroot: trying cd9660...
mountroot: trying lfs...   
mountroot: trying nfs...
mountroot: trying ffs...
WARNING: clock lost 11557 days -- CHECK AND RESET THE DATE!
root file system type: ffs                                 
init: copying out path `/sbin/init' 11
erase ^?, werase ^W, kill ^U, intr ^C 

Terminal type (just hit ENTER for ''):