mlx0 at pci0 dev 2 function 0: Mylex RAID (v3 interface) mlx0: interrupting at ivec 10 mlx0: initializing (may take some time)... mlx0: physical drive 2:0 not responding mlx0: physical drive 2:1 not responding mlx0: physical drive 2:2 not responding mlx0: physical drive 2:3 not responding mlx0: logical drive installation aborted mlx0: initialization complete mlx0: DAC960P/PD, 3 channels, firmware 3.51-0-09, 4MB RAM ppb0 at pci0 dev 4 function 0: Intel product 0x0960 (rev. 0x03) pci1 at ppb0 bus 1 mlx1 at pci0 dev 4 function 1: Mylex RAID (v4 interface) mlx1: interrupting at ivec 18 mlx1: DAC960PG, 2 channels, firmware 4.06-0-85, 16MB RAMppb1 at pci0 dev 5 function 0: Digital Equipment DC21154 PCI-PCI Bridge (rev. 0x02)
pci2 at ppb1 bus 2Distributed Processing Technology Memory Controller (miscellaneous memory, revision 0x02) at pci2 dev 3 function 0 not configured iop0 at pci2 dev 4 function 0: I2O adapteriop0: reset rejected, status 0x0
iop0: not responding (reset)basically the whole setup looks fishy to me. mlx0 gets initialized, mlx1 not. And the DPT PM3755U2B controller (which is basically the single channel version of the SUN SRC/P controller) is not accessible (I have created the relevant node entries...)
# mlxctl -f /dev/mlx0 -v cstatus DAC960P/PD, 3 channels, firmware 3.51-0-09, 4MB RAM mlxctl: cmd 0x1c failed: Operation not permitted # mlxctl -f /dev/mlx1 -v cstatus DAC960PG, 2 channels, firmware 4.06-0-85, 16MB RAM mlxctl: cmd 0x1c failed: Operation not permitted # mlxctl -f /dev/mlx0 -v config mlxctl: cmd 0x4e failed: Operation not permitted # mlxctl -f /dev/mlx1 -v config mlxctl: cmd 0x4e failed: Operation not permitted # iopctl showstatus iopctl: /dev/iop0: Device not configuredthis is on a DEBUG+DIAGNOSTIC kernel, is there some magic needed to actually enable debug output?
Is anyone actually using any hardware raid on sparcs?
Cheers
Oskar
Attachment:
PGP.sig
Description: This is a digitally signed message part