Kouichirou Hiratsuka wrote:
> Hello,
>
> At Tue, 28 Aug 2007 10:15:36 +0900 (JST),
> SAITOH Masanobu wrote:
>   
>>  I've added the ICH9 support for wm. To do this, I had to modify wm_reset().
>> If you got worse, please report to me ASAP.
>>     
>
> It seems to be worked for me.  However, I get this message.
>
> wm0: auto read from eeprom failed to complete
>
> Hardware:
>
> wm0 at pci2 dev 1 function 0: Intel i82540EP 1000BASE-T Ethernet, rev. 3
> wm0: interrupting at irq 11
> wm0: 32-bit 33MHz PCI bus
> wm0: auto read from eeprom failed to complete
> wm0: 64 word (6 address bits) MicroWire EEPROM
> wm0: Ethernet address 00:10:c6:dc:7d:b5
> makphy0 at wm0 phy 1: Marvell 88E1011 Gigabit PHY, rev. 4
> makphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT, 1000baseT-FDX, auto
>
> best regards.
>   
Same for me.
Network card works OK, but I get the "wm0: auto read from eeprom failed 
to complete" message as well.
Hardware is the same:

% dmesg | grep wm0                                                      
[22:58]
wm0 at pci2 dev 1 function 0: Intel i82540EP 1000BASE-T Ethernet, rev. 3
wm0: interrupting at irq 11
wm0: 32-bit 33MHz PCI bus
wm0: auto read from eeprom failed to complete
wm0: 64 word (6 address bits) MicroWire EEPROM
wm0: Ethernet address 00:0d:60:cd:9b:15
makphy0 at wm0 phy 1: Marvell 88E1011 Gigabit PHY, rev. 4
wm0: auto read from eeprom failed to complete
wm0: auto read from eeprom failed to complete
wm0: auto read from eeprom failed to complete