Re: Kingston Data Traveler

["Thomas Mueller" <mueller6724%bellsouth.net@localhost>]

> Just a data point - I've got a similar one which also works fine under
> -current (and as far as I remember under any NetBSD I've ever tried it
> on):
         
> ....
> umass0 at uhub6 port 2 configuration 1 interface 0
> umass0: Kingston DataTraveler 2.0, rev 2.00/1.10, addr 2
> umass0: using SCSI over Bulk-Only
> scsibus0 at umass0: 2 targets, 1 lun per target
> sd0 at scsibus0 target 0 lun 0: <Kingston, DataTraveler 2.0, PMAP>
> disk removable
> sd0: 3832 MB, 15328 cyl, 16 head, 32 sec, 512 bytes/sect x 7847936 sectors
 
> ....
> Controller /dev/usb6:
> addr 1: high speed, self powered, config 1, EHCI root hub(0x0000),
> vendor 0x8086(0x8086), rev 1.00
>  port 1 powered
>  port 2 addr 2: high speed, power 200 mA, config 1, DataTraveler
> 2.0(0x6545), Kingston(0x0930), rev 1.10, serial 5B840800032E
>  port 3 powered
>  port 4 powered
>  port 5 powered
>  port 6 powered
 
 
> Notice the power; also the geometry on the one that doesn't work seems
> to be incorrectly derived, showing only about 1GB.
 
 
> Chavdar Ivanov

I see a difference in the power, but don't see any geometry about 1 GB, only 
sd0: 3832 MB.

> Interestingly, this vendor is listed in NetBSD as Toshiba..  you could try
> the patch below to see if it is affected by the same issue as other
> Kingston drives..
 
> iain
 
> Index: umass_quirks.c

This issue only affects one lot of Kingston Data Travelers that I have: a 
discontinued model made specifically for sale through Office Depot.

Other Kingston Data Travelers, older and newer, are OK with NetBSD.


Tom