I have the following configuration:

	Single Pentium Pro 200 MHz
	Adaptec 2940 Ultra/Ultra W BIOS v1.23
	Seagate ST32550N SCSI Drive
	ARCHIVE Python 00095-001 DAT Drive
	96 MB Memory
	256K L2 Cache

I tried to use the "kcadp12.fs" to do the intsall.  The install bombs
out and I get the following:

	scsibus0 at ahc1
	ahc1: targe 0 synchronous at 10.0MHz, offset= 0xf
	sd0 at scsibus0 targ 0 lun 0: <SEAGATE, ST32550N, 0019> SCSI2 0/direct
fixed
	sd0: 2047MB, 3511 cyl, 11 head, 108 sec, 512 bytes/sec
	ahc1:A:6: refuses WIDE negotiation.  Using 8bit transfers
	ahc1: board is not responding
	cmd fail
	probe(ahc1:6:0): timed out in datain phase, SCSISIGI == 0x44
	probe(ahc1:0:0): asserted ATN - device reset in message buffer
	ahc1: board is not responding
	cmd fail
	sd1 at scsibus0 targ 6 lun 0: <, , > SCSI0 0/direct fixed
	sd1: ahc1: board is not responding
	ahc1: board is not responding
	cmd fail
	ahc1: board is not responding
	cmd fail
	fail integer divide fault in supervisor mode
	trap type 8 code 0 eip f8185c8d cs 8 eflags 10246 cr2 0 cpl ffffffff
	panic: trap

	The operating system has halted
	Please press any key to reboot


Any ideas?  Thanks for any help.






/abp

--
Adam B. Plummer
Metamor Technologies, Ltd.
One North Franklin St. (Suite 1500)
Chicago, IL  60606
WWW:	http://www.metamor.com/
E-Mail:	adam.plummer@metamor.com
Phone:	(312) 251-2455
Fax:	(312) 251-2999
Pager:	(312) 910-0395 or adam.plummer@pager.metamor.com