On Mar 10,  8:45am, timo.schoeler@riscworks.net (timo.schoeler@riscworks.net) wrote:
-- Subject: kern/33047: fxp NICs are not useable on IBM Netfinity 4000R (no l

| e100: Intel(R) PRO/100 Network Driver, 3.3.6-k2-NAPI
| e100: Copyright(c) 1999-2004 Intel Corporation
| e100: eth0: e100_probe: addr 0xfebff000, irq 9, MAC addr 00:06:29:DE:7C:29
| e100: eth1: e100_probe: addr 0xfebfe000, irq 10, MAC addr 00:06:29:DE:7C:28
| 
| ---
| 
| NetBSD specific information (gathered via serial console, no typos! :)
| 
| *** ifconfig -a output ***
| 
| netbsd# ifconfig -a
| fxp0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
|         address: 00:06:29:de:87:39
|         media: Ethernet autoselect (none flowcontrol,rxpause,txpause)
                                      ^^^^
|         status: no carrier
|         inet6 fe80::206:29ff:fede:8739%fxp0 prefixlen 64 scopeid 0x1
| 
| fxp0 at pci0 dev 17 function 0: i82559 Ethernet, rev 8
| fxp0: interrupting at ioapic0 pin 18 (irq 10)
| fxp0: Ethernet address 00:06:29:de:87:39
| inphy0 at fxp0 phy 1: i82555 10/100 media interface, rev. 4
| inphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
          ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
| fxp1 at pci0 dev 18 function 0: i82559 Ethernet, rev 8
| fxp1: interrupting at ioapic0 pin 17 (irq 11)
| fxp1: Ethernet address 00:06:29:de:87:38
| inphy1 at fxp1 phy 1: i82555 10/100 media interface, rev. 4
| inphy1: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto

Is your ifconfig program old? What happens if you try to set the
media manually?

christos