Subject: Re: kern/35376: re(4) doesn't auto-negotiate properly on GigE
To: None <gnats-bugs@NetBSD.org>
From: Izumi Tsutsui <tsutsui@ceres.dti.ne.jp>
List: netbsd-bugs
Date: 01/08/2007 13:26:32
smb@cs.columbia.edu wrote:
> >How-To-Repeat:
> See above
Could you please post more details of your environment?
- dmesg (exact chip revision, what mii(4) is attached etc)
- output of "ifconfig re0"
My re0 works fine without problem.
---
# dmesg
:
re0 at pci2 dev 5 function 3: RealTek 8169S Single-chip Gigabit Ethernet
re0: interrupting at ioapic0 pin 16 (irq 9)
re0: Ethernet address 00:e0:4c:77:73:6d
re0: using 256 tx descriptors
rgephy0 at re0 phy 7: RTL8169S/8110S 1000BASE-T media interface, rev. 0
rgephy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT, 1000baseT-FDX, auto
:
# ifconfig re0
re0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
capabilities=3f80<TSO4,IP4CSUM_Rx,IP4CSUM_Tx,TCP4CSUM_Rx,TCP4CSUM_Tx,UDP4CSUM_Rx,UDP4CSUM_Tx>
enabled=3f00<IP4CSUM_Rx,IP4CSUM_Tx,TCP4CSUM_Rx,TCP4CSUM_Tx,UDP4CSUM_Rx,UDP4CSUM_Tx>
address: 00:e0:4c:77:73:6d
media: Ethernet autoselect (1000baseT full-duplex)
status: active
inet 192.168.20.1 netmask 0xffffff00 broadcast 192.168.20.255
inet6 fe80::2e0:4cff:fe77:736d%re0 prefixlen 64 scopeid 0x2
---
Izumi Tsutsui