Subject: Re: kern/37279: usb and cdrom don't work after resume on PM branch
To: None <kern-bug-people@netbsd.org, gnats-admin@netbsd.org,>
From: Juan RP <juan@xtrarom.org>
List: netbsd-bugs
Date: 11/04/2007 23:15:10
The following reply was made to PR kern/37279; it has been noted by GNATS.
From: Juan RP <juan@xtrarom.org>
To: "Steven M. Bellovin" <smb@cs.columbia.edu>
Cc: gnats-bugs@NetBSD.org, jmcneill@invisible.ca
Subject: Re: kern/37279: usb and cdrom don't work after resume on PM branch
Date: Mon, 5 Nov 2007 00:13:03 +0100
On Sun, 4 Nov 2007 22:56:15 +0000
"Steven M. Bellovin" <smb@cs.columbia.edu> wrote:
> It is. Rather, the only option I see (and I'll go look again) is set
> to SATA, and the disk is using it, but not the CD:
>
> piixide0 at pci0 dev 31 function 1
> piixide0: Intel 82801HBM IDE Controller (ICH8M) (rev. 0x03)
> piixide0: bus-master DMA support present
> piixide0: primary channel configured to compatibility mode
> piixide0: primary channel interrupting at irq 14
> atabus0 at piixide0 channel 0
> atabus0: using generic power management <D0,D1,D3>
> piixide0: secondary channel configured to compatibility mode
> piixide0: secondary channel ignored (disabled)
> piixide0: using generic power management <D0,D3>
> ahcisata0 at pci0 dev 31 function 2: Intel 82801HBM SATA Controller
> ahcisata0: interrupting at irq 10
> ahcisata0: AHCI revision 1.1, 3 ports, 32 command slots, features
> 0xe710e080 atabus1 at ahcisata0 channel 0
> atabus1: using generic power management <D0,D1,D3>
> ahcisata0: using generic power management <D0,D3>
> ...
> atapibus0 at atabus0: 2 targets
> cd0 at atapibus0 drive 0: <HL-DT-ST DVDRAM GSA-U10N, KZ27AG42356, 1.05>
> cdrom re movable
> cd0: WARNING: power management not supported
> cd0: 32-bit data port
> cd0: drive supports PIO mode 4, DMA mode 2, Ultra-DMA mode 2 (Ultra/33)
> atapibus0: WARNING: power management not supported
> cd0(piixide0:0:0): using PIO mode 4, Ultra-DMA mode 2 (Ultra/33) (using
> DMA) ahcisata0 port 0: device present, speed: 1.5Gb/s
> wd0 at atabus1 drive 0ugen0 at uhub0 port 2
>
There is not support for ATAPI devices on ahcisata(4)... AFAIK.
--
Juan Romero Pardines - The NetBSD Project
http://plog.xtrarom.org - NetBSD/pkgsrc news in Spanish