Re: install/58057: Installer segfaults when trying to encrypt a partition

Hello.

I will provide screenshots, so it's easier to understand.

After creating two partitions I see a screen like 1.png

Then I select one of the partitions, then I press enter and a small menu shows in the left side, as shown in 2.png

In that little menu y select "Encrypt (CGD)" as shown in 3.png.

Then I press enter and I see a segmentation fault message, as shown in 4.png

I hope those screenshots help. If any further questions arise, I'm happy to help.

El dom, 24 mar 2024 a las 18:50, Martin Husemann (<martin%duskware.de@localhost>) escribió:

The following reply was made to PR install/58057; it has been noted by GNATS.

From: Martin Husemann <martin%duskware.de@localhost>
To: gnats-bugs%netbsd.org@localhost
Cc:
Subject: Re: install/58057: Installer segfaults when trying to encrypt a
partition
Date: Sun, 24 Mar 2024 18:49:32 +0100

On Wed, Mar 20, 2024 at 10:20:01PM +0000, roddy.gonzalez.89%gmail.com@localhost wrote:
> 3. Create two partitions on virtual drive (GPT, MBR or disklabel)
> 4. Select one of the partitions. And then "Encrypt (CGD)" on the partition.

Can you please describe the steps in (3) in more details?
I am unable to reproduce the issue.

Side note: I totally fail to understand the UI that pops up when you
select "Encrypt (CGD)", it asks for a "base device" and doesn't offer
the device this partition is on in it's list of available disks.

Martin