Hello,  I used Ethernet LAN card NE2000.  I tried to install NetBSD-1.0.  
First I cannot install NetBSD-1.0.  It hang up after the program checking 
diskette drive (A: and B:).  I tried to change diskette but it still hang 
up then I removed my LAN card from computer.  I can finish installation 
NetBSD without LAN card.  If I want to install my LAN card,  How can I do?
	I read from file INSTALL (line 510) tell me how to config device:

	ed0  0x280  2    iomem 0xd0000
	ed1  0x250  2    iomem 0xd8000
	ed2  0x300  10   iomem 0xcc000

	Please explain this information for me.  I have only one NE2000 
card in my computer.  My LAN card can set IRQ 3,4,5,9,10,11,15 and I/O 
base address 300h, 320h, 340h, 360h.  I cannot set my LAN card to IRQ 
2 and I/O address 280h.  I'm not sure about file INSTALL.  What I must 
configured my computer and LAN card.    How can I do?   Can I use  0x300  
and IRQ 10 for first LAN card (ed0).   Please explain me.   And I want to 
connect between NetBSD and Netware.  How can I do it?  Please tell me how to setup 
netware and NetBSD. I know only I must use IPXODI from NetWare and how 
about NetBSD (What I must config NetBSD).  
					Thank you very much for your kindness.