Hi Ben and All,

Well, the installation of NetBSD on my old Pentium
75mhz went very well.  On first restart, she booted
great, and I had a working unix distro in less than a
couple of hours.  It was also one of the easiest
installations that I have ever done!

Anyway, I noticed that my new D-link card is not being
recognized by the OS.  I know you state some
configurations below, but how do I configure it?  I'm
really new to NetBsd and unix as a whole and would
like to get this computer on my network so I could set
up the web server software.

--- Nate Hill <vugdeox@freeshell.org> wrote:
> Most likely, my card worked in an old IBM330 (Intel
> Pentium 100Mhz)

Also, Nate, thank you very much for the info.  I
installed the card and so far I haven't had any major
problems except that it is not recognized by the OS. 
But the LEDs do turn on, and before I installed
NetBSD, Windows did recognize the card.

Thanks again,
J Silverman

--- collver1@comcast.net wrote:
> Hi,
> 
> I use a lot of DFE-530TX+'s at home because I bought
> some on sale.  They
> work just fine.  However you wouldn't want to use
> them in a busy server
> because there may be performance issues with that
> realtek chipset.
> 
> rtk0 at pci0 dev 10 function 0: D-Link Systems DFE
> 530TX+
> rtk0: interrupting at irq 9
> rtk0: Ethernet address XX:XX:XX:XX:XX:XX
> ukphy0 at rtk0 phy 7: Generic IEEE 802.3u media
> interface
> ukphy0: OUI 0x000000, model 0x0000, rev. 0
> ukphy0: 10baseT, 10baseT-FDX, 100baseTX,
> 100baseTX-FDX, auto
> 
> Cheers,
> 
> Ben
> 

__________________________________
Do you Yahoo!?
The New Yahoo! Shopping - with improved product search
http://shopping.yahoo.com