Re: Marvell sk/msk driver NetBSD 8.0_RC1

[John Halfpenny <jsh%SDF.ORG@localhost>]

On Sat, Jun 09, 2018 at 08:56:16PM +0200, Jarom?r Dole?ek wrote:
> I had a look, the driver has also second match routine, which needs to
> be updated too.
> 
> I've committed change on -current to match several Yukon variants
> including yours, can you check if it would work for you by chance?
> 
> But I suspect you might hit the same problem as Chris did in
> kern/53301. Unfortunately I don't have the hardware, so can't really
> work on this further.
> 

Ok, I got it updated to current.

The device seems to have detected, however when I attempt to connect over DHCP it locks up the machine, 
and I have to do a cold reboot to get it going again.

[    1.045467] mskc0 at pci1 dev 0 function 0, Yukon-2 Extreme rev. B0 (0x2): ioapic0 pin 16
[    1.045467] msk0 at mskc0 port A: Ethernet address 00:1d:72:eb:86:41
[    1.045467] makphy0 at msk0 phy 0: Marvell 88E1149 Gigabit PHY, rev. 1
[    1.002124] mskc0 at pci1 dev 0 function 0, Yukon-2 Extreme rev. B0 (0x2): ioapic0 pin 16
[    1.002124] msk0 at mskc0 port A: Ethernet address 00:1d:72:eb:86:41
[    1.002124] makphy0 at msk0 phy 0: Marvell 88E1149 Gigabit PHY, rev. 1

^ The output from dmesg shows the device but the model number is incorrect. It is an 88E8071.

I appreciate the effort and difficulty in amending a driver for a device in someone else's machine.

I'm planning on getting a usb<>ethernet adapter but will leave it on current for a while if there's any 
more info you might need. No worries if not though.

Thanks for the effort!

John  

-- 
jsh%sdf.org@localhost
SDF Public Access UNIX System - http://sdf.org