bioctl cosmetic issue

[John Klos <john%ziaspace.com@localhost>]

Hi,

I just set up an LSI MegaRAID controller with four 10 TB drives which 
happen to be 4K sector drives. Everything works swimmingly, but I did 
notice that bioctl isn't yet aware of 4K blocks.

Here's my mfii0 and RAID volume:

[     1.033007] mfii0 at pci1 dev 0 function 0: "LSI MegaRAID SAS 9271-4i", firmware 23.34.0-0019, 1024MB cache
[     1.033007] mfii0: interrupting at ioapic1 pin 0
[     1.033007] mfii0: Max 256 VD support
[     1.033007] scsibus0 at mfii0: 64 targets, 8 luns per target
[     1.666498] scsibus0: waiting 2 seconds for devices to settle...
[     1.676499] mfii0: physical disk inserted id 13 enclosure 252
[     1.676499] mfii0: physical disk inserted id 14 enclosure 252
[     1.686482] mfii0: physical disk inserted id 15 enclosure 252
[     1.696482] uhub2 at usb5mfii0: physical disk inserted id 16 enclosure 252
[     3.676491] sd0 at scsibus0 target 0 lun 0: <LSI, MR9271-4i, 3.46> disk fixed
[     3.676491] sd0: fabricating a geometry
[     3.686500] sd0: 27745 GB, 3551424 cyl, 64 head, 32 sec, 4096 bytes/sect x 7273316352 sectors
[     3.696496] sd0: fabricating a geometry
[     3.716491] sd0: tagged queueing

The size is correct and everything is fast and works well :)

However, bioctl is showing me sizes based on the assumption of 512 byte 
sectors:

doozer# bioctl mfii0 show
Volume Status       Size         Device/Label    Level Stripe
=============================================================
     0 Online       3.4T                        RAID 5  1024K
   0:0 Online       1.1T         1:0.0 noencl <SEAGATE ST10000NM0226   KTB5>
   0:1 Online       1.1T         1:1.0 noencl <SEAGATE ST10000NM0226   KTB5>
   0:2 Online       1.1T         1:2.0 noencl <SEAGATE ST10000NM0226   KTB5>
   0:3 Online       1.1T         1:3.0 noencl <SEAGATE ST10000NM0226   KTB5>

Where is bioctl supposed to get the sector size?

Thanks,
John