Re: freecad (was: Re: Anyone able to run blender on netbsd-10 amd64?)

[Robert Swindells <rjs%fdy2.co.uk@localhost>]

mlh%goathill.org@localhost (MLH) wrote:
> Robert Swindells wrote:
>> 
>> Paul Ripke <stix%stix.id.au@localhost> wrote:
>> > On Fri, Feb 14, 2025 at 05:25:59PM -0500, MLH wrote:
>> > > 
>> > > FreeCAD 1.0 came out recently and I will offer a bounty for it to
>> > > be in pkgsrc, buildable under amd64 at least. I want to build cases,
>> > > etc. for 3dp using Python and that is a burden with win11.
>> > 
>> > I'm currently replacing/rebuilding my main netbsd-10 dev box, once
>> > that's done, I hope to come back to this.
>> > 
>> > I've also started looking at FreeCAD previously - I've been using
>> > OnShape and OpenSCAD, but more options are always good. I'm still
>> > bogged down going thru the python dependencies. Once I get this new
>> > box working, I'll continue and check in whatever I have into WIP.
>> 
>> I added py-pyside-setup to wip, this seems to be needed for freecad 1.0.
>> 
>> Not got it to build yet, it gets further using Python 3.11 than 3.12,
>> working through the PLIST right now.
>
> Interesting... Thanks very much!! 

I just pushed an update to wip that does make it build, not sure it is
wrapping all of the Qt5 components needed for freecad though.

Also have local changes to update graphics/coin to 4.0.3.

Working though the cmake config for freecad now, can push my interim
changes to wip/freecad if anyone is interested.