Subject: Re: Alpha 1.3I snapshot
To: None <root@garbled.net>
From: Mito Osamu <mito@st.rim.or.jp>
List: port-alpha
Date: 02/03/1999 18:11:01
Sorry, I tried Alpha Station BIOS update.
It came to work normally when it went through BIOS update.
Add this matter to install TIPS by all means.
BIOS URL:
http://ftp.digital.com/pub/DEC/Alpha/firmware/
Thank you very much.
----
mito
----
Before BIOS update
>>>show config
Firmware
SRM Console: V4.2-3
show_arc: Can't find Flash Rom containing ARC console.
PALcode: VMS PALcode X5.48-100, OSF PALcode X1.35-67
Serial Rom: V4.6
Diag Rom: V1.7
Processor
DECchip (tm) 21064A-6 100Mhz 512KB Cache
MEMORY
64 Meg of System Memory
Bank 0 = 64 Mbytes(32 MB Per Simm) Starting at 0x0
Bank 1 = No Memory Detected
Bank 2 = No Memory Detected
Flash ROM0 Mfr - AMD
Flash ROM1 Mfr - AMD
Flash ROM2 Mfr - No Memory Detected
Flash ROM3 Mfr - No Memory Detected
PCI Bus
Bus 00 Slot 06: NCR 810 Scsi Controller
pka0.7.0.6.0 SCSI Bus ID 7
dka0.0.0.6.0 RZ28M
Bus 00 Slot 07: Intel SIO 82378
Bus 00 Slot 11: DECchip 21040 Network Controller
ewa0.0.0.11.0 00-00-F8-21-66-F8
ISA
Slot Device Name Type Enabled BaseAddr IRQ DMA
0
0 MOUSE Embedded Yes 60 12
1 KBD Embedded Yes 60 1
2 COM1 Embedded Yes 3f8 4
3 COM2 Embedded Yes 2f8 3
4 LPT1 Embedded Yes 3bc 7
5 FLOPPY Embedded Yes 3f0 6 2
2
0 PCXBJ Singleport Yes 530 9 0
>>>
------
After BIOS update
>>>show config
Firmware
SRM Console: V6.9-4
show_arc: Can't find Flash Rom containing ARC console.
PALcode: VMS PALcode V5.56-2, OSF PALcode X1.46-2
Serial Rom: V4.6
Diag Rom: V1.7
Processor
DECchip (tm) 21064A-2 100Mhz 512KB Cache
MEMORY
64 Meg of System Memory
Bank 0 = 64 Mbytes(32 MB Per Simm) Starting at 0x0
Bank 1 = No Memory Detected
Bank 2 = No Memory Detected
PCI Bus
Bus 00 Slot 06: NCR 810 Scsi Controller
pka0.7.0.6.0 SCSI Bus ID 7
dka0.0.0.6.0 RZ28M
Bus 00 Slot 07: Intel SIO 82378
Bus 00 Slot 11: DECchip 21040 Network Controller
ewa0.0.0.11.0 00-00-F8-21-66-F8
ISA
Slot Device Name Type Enabled BaseAddr IRQ DMA
0
0 MOUSE Embedded Yes 60 12
1 KBD Embedded Yes 60 1
2 COM1 Embedded Yes 3f8 4
3 COM2 Embedded Yes 2f8 3
4 LPT1 Embedded Yes 3bc 7
5 FLOPPY Embedded Yes 3f0 6 2
2
0 PCXBJ Singleport Yes 530 9 0
388 1
>>>
--------
1.3I GENERIC from
ftp.jp.netbsd.org:/pub/NetBSD/arch/alpha/snapshot/19990122/binary/sets/kern.tgz
MD5 (netbsd) = 557eb5de48612cad6e6d6c8543757d53
halted CPU 0
halt code = 5
HALT instruction executed
PC = fffffc0000300140
CPU 0 booting
(boot dka0.0.0.6.0 -flags a)
block 0 of dka0.0.0.6.0 is a valid boot block
reading 15 blocks from dka0.0.0.6.0
bootstrap code read in
base = 1f2000, image_start = 0, image_bytes = 1e00
initializing HWRPB at 2000
initializing page table at 1e4000
initializing machine state
setting affinity to the primary CPU
jumping to bootstrap code
NetBSD/Alpha Primary Boot
Jumping to entry point...
NetBSD/Alpha Secondary Boot, Revision 1.9
(ross@zeta, Fri Dec 11 17:21:15 PST 1998)
VMS PAL revision: 0x1000000010538
OSF PAL rev: 0x100000002012e
Switch to OSF PAL code succeeded.
Boot flags: a
Loading netbsd...
2674072+280800 [85+140136+84873]
Entering netbsd at 0xfffffc0000301040...
[ preserving 226000 bytes of netbsd ELF symbol table ]
consinit: not using prom console
Copyright (c) 1996, 1997, 1998, 1999
The NetBSD Foundation, Inc. All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
NetBSD 1.3I (GENERIC) #0: Mon Jan 25 00:49:42 MST 1999
root@giauzar:/usr/srcwork/snap/src/sys/arch/alpha/compile/GENERIC
AlphaStation 200 4/100, 100MHz
8192 byte page size, 1 processor.
real mem = 67108864 (2048000 reserved for PROM, 65060864 used by NetBSD)
avail mem = 53764096
using 794 buffers containing 6504448 bytes of memory
mainbus0 (root)
cpu0 at mainbus0: ID 0 (primary), 21064A ()
apecs0 at mainbus0: DECchip 21071 Core Logic chipset
apecs0: DC21071-CA pass 2, 64-bit memory bus
apecs0: DC21071-DA pass 2
pci0 at apecs0 bus 0
pci0: i/o enabled, memory enabled
ncr0 at pci0 dev 6 function 0: ncr 53c810 fast10 scsi
ncr0: interrupting at isa irq 11
ncr0: minsync=25, maxsync=206, maxoffs=8, 16 dwords burst, normal dma fifo
ncr0: single-ended, open drain IRQ driver
ncr0: restart (scsi reset).
scsibus0 at ncr0: 8 targets, 8 luns per target
sd0 at scsibus0 targ 0 lun 0: <DEC, RZ28M (C) DEC, 0568> SCSI2 0/direct fixed
sd0(ncr0:0:0): 10.0 MB/s (100 ns, offset 8)
sd0: 2007MB, 3045 cyl, 16 head, 84 sec, 512 bytes/sect x 4110480 sectors
sio0 at pci0 dev 7 function 0: Intel 82378ZB System I/O (SIO) (rev. 0x84)
de0 at pci0 dev 11 function 0
de0: interrupting at isa irq 5
de0: DEC 21040 [10Mb/s] pass 2.4
de0: address 00:00:f8:21:66:f8
isa0 at sio0
com0 at isa0 port 0x3f8-0x3ff irq 4: ns16550a, working fifo
com0: console
com1 at isa0 port 0x2f8-0x2ff irq 3: ns16550a, working fifo
lpt0 at isa0 port 0x3bc-0x3bf irq 7
pckbc0 at isa0 port 0x60-0x64
pcppi0 at isa0 port 0x61
spkr0 at pcppi0
isabeep0 at pcppi0
mcclock0 at isa0 port 0x70-0x71: mc146818 or compatible
root on sd0a dumps on sd0b
root file system type: ffs
de0: enabling 10baseT port
swapctl: adding /dev/sd0b as swap device at priority 0
Automatic boot in progress: starting file system checks.
/dev/rsd0a: file system is clean; not checking
/dev/rsd0f: file system is clean; not checking
/dev/rsd0g: file system is clean; not checking
setting tty flags
starting network
hostname: lala
configuring network interfaces: de0de0: enabling 10baseT port
.
adding interface aliases:
starting system logger
checking for core dump...
savecore: no core dump
starting rpc daemons:.
mount_kernfs: : Operation not supported by device
mount_procfs: : Operation not supported by device
starting nfs daemons:.
checking quotas: done.
building databases...
clearing /tmp
updating motd.
standard daemons: update cron.
starting network daemons: routed xntpd.
starting local daemons: sshdFeb 3 16:54:05 lala routed[118]: sendto(de0, 224.0.0.2): No route to host
.
Wed Feb 3 16:54:06 JST 1999
Feb 3 16:54:07 lala init: kernel security level changed from 0 to 1
Feb 3 16:54:08 lala routed[118]: sendto(de0, 224.0.0.2): No route to host
NetBSD/alpha (lala) (console)
login:
--------