Hal Murray <murray@pa.dec.com> writes:

> Anybody running on an "a" series Miata?  If so, can you send me the 
> dmesg printout? 

This is from an `old' a-series (w/o usb, and on-board scsi).

[ preserving 159432 bytes of netbsd ELF symbol table ]
Copyright (c) 1996, 1997, 1998, 1999
    The NetBSD Foundation, Inc.  All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
    The Regents of the University of California.  All rights reserved.

NetBSD 1.4 (CHOWDER) #3: Mon May 17 13:41:11 CEST 1999
    root@chowder.pdc.kth.se:/usr/src/sys/arch/alpha/compile/CHOWDER
Digital Personal WorkStation 433au, 432MHz
8192 byte page size, 1 processor.
real mem = 67108864 (1933312 reserved for PROM, 65175552 used by NetBSD)
avail mem = 54747136
using 795 buffers containing 6512640 bytes of memory
mainbus0 (root)
cpu0 at mainbus0: ID 0 (primary), 21164A ()
cpu0: VAX FP support, IEEE FP support, Primary Eligible
cia0 at mainbus0: DECchip 2117x Core Logic Chipset (Pyxis), pass 1
cia0: extended capabilities: 1<BWEN>
cia0: using BWX for PCI config access
cia0: WARNING: Pyxis pass 1 DMA bug; no bets...
pci0 at cia0 bus 0
pci0: i/o enabled, memory enabled
de0 at pci0 dev 3 function 0
de0: interrupting at dec 550 irq 8
de0: DEC 21143 [10-100Mb/s] pass 3.0
de0: address 00:00:f8:75:77:2a
pciide0 at pci0 dev 4 function 0: CMD Technology PCI0646
pciide0: bus-master DMA support present
pciide0: primary channel wired to compatibility mode
atapibus0 at pciide0 channel 0
cd0 at atapibus0 drive 0: <TOSHIBA CD-ROM XM-5702B, 8500712668, 3476> type 5 cdrom removable
cd0: 32-bits data port
cd0: drive supports PIO mode 3, DMA mode 1
pciide0: secondary channel wired to compatibility mode
pciide0: disabling secondary channel (no drives)
cd0(pciide0:0:0): using PIO mode 3, DMA mode 1 (using DMA data transfers)
sio0 at pci0 dev 7 function 0: Intel 82378ZB System I/O (SIO) (rev. 0x43)
ppb0 at pci0 dev 20 function 0: Digital Equipment DECchip 21052 PCI-PCI Bridge (rev. 0x02)
pci1 at ppb0 bus 1
pci1: i/o enabled, memory enabled
isp0 at pci1 dev 8 function 0
Qlogic ISP Driver, NetBSD (pci) Platform Version 0.993 Core Version 1.7
isp0: interrupting at dec 550 irq 20
isp0: Ultra Mode Capable
isp0: Board Revision 1040B, loaded F/W Revision 7.55
isp0: Last F/W revision was 5.54
isp0: driver initiated bus reset
scsibus0 at isp0: 16 targets, 8 luns per target
sd0 at scsibus0 targ 0 lun 0: <IBM, DDRS-34560W, S71D> SCSI2 0/direct fixed
sd0: 4357MB, 8387 cyl, 5 head, 212 sec, 512 bytes/sect x 8925000 sectors
sd1 at scsibus0 targ 2 lun 0: <CONNER, CFP2105S  2.14GB, 1524> SCSI2 0/direct fixed
sd1: 2048MB, 3940 cyl, 10 head, 106 sec, 512 bytes/sect x 4194304 sectors
isa0 at sio0
com0 at isa0 port 0x3f8-0x3ff irq 4: ns16550a, working fifo
com0: console
com1 at isa0 port 0x2f8-0x2ff irq 3: ns16550a, working fifo
lpt0 at isa0 port 0x3bc-0x3bf irq 7
pckbc0 at isa0 port 0x60-0x64
pckbdprobe: reset error 5
pmsprobe: reset error 5
pcppi0 at isa0 port 0x61
spkr0 at pcppi0
isabeep0 at pcppi0
fdc0 at isa0 port 0x3f0-0x3f7 irq 6 drq 2
fd0 at fdc0 drive 0: 1.44MB, 80 cyl, 2 head, 18 sec
mcclock0 at isa0 port 0x70-0x71: mc146818 or compatible
root on sd0a dumps on sd0b
de0: enabling Full Duplex 100baseTX port
mountroot: trying nfs...
mountroot: trying msdos...
isp0: Target 0 at 20MHz Max Offset 8, 16 bit wide, Tagged Queueing Enabled
mountroot: trying cd9660...
mountroot: trying ffs...
readclock: 47/8/13/10/47/26=>934541246 (933079702)
WARNING: clock gained 16 days -- CHECK AND RESET THE DATE!
root file system type: ffs
init: copying out path `/sbin/init' 11
setclock: 47/8/13/10/47/39

> How many internal disk slots?

There are three 5.25" front-accessibly bays, and two 3.5" (1" hight)
internal bays (+ floppy).

>   The PCI-ISA bridge chip includes IDE controllers.  Does the motherboard 
>   have connectors?  

Yes.

> Anybody tried it?

It works, but SRM only likes some (= not all) disks.

/Johan