Ok, sorry you had problems. To verify...

> From: Sven Dietrich <spock@sled.gsfc.nasa.gov>
>
> Having problems with a new XP1000:
>
> - loaded 1.4.1 (up and limping - works fine on old XP1000/500MHz)
> - "upgraded" to 1.4P (snapshot 19991223) due to SCSI problems
> - getting "stray 6600 irq 47" messages, then messages about the
>   SCSI controller having loaded an earlier firmware. These
>   messages appear when accessing the disk (like gunzip'ing a
>   file):

The stray irq message is the problem with the 1223 snap on the new XP1000?

> isp0: Ultra Mode Capable
> isp0: Board Revision 1040C, loaded F/W Revision 4.65.0
> isp0: Last F/W revision was 5.57.1
> isp0: 243 max I/O commands supported
> isp0: enabled FW features (0x1)

> - system dies subsequently

This is what happened with 1.4.1 on the new HW? But 1.4.1 worked OK on the
old XP1000?

	ross