> Ok, sorry you had problems. To verify...
> 
> > From: Sven Dietrich <spock@sled.gsfc.nasa.gov>
> >
> > Having problems with a new XP1000:
> >
> > - loaded 1.4.1 (up and limping - works fine on old XP1000/500MHz)
> > - "upgraded" to 1.4P (snapshot 19991223) due to SCSI problems
> > - getting "stray 6600 irq 47" messages, then messages about the
> >   SCSI controller having loaded an earlier firmware. These
> >   messages appear when accessing the disk (like gunzip'ing a
> >   file):
> 
> The stray irq message is the problem with the 1223 snap on the new XP1000?

Correct. There were similar experiences with the 1.4.1, if I did
manage to boot with it on the new XP1000.
 
> 
> This is what happened with 1.4.1 on the new HW? But 1.4.1 worked OK on the
> old XP1000?
> 

Yes, both with 1.4.1 (when it did boot) and with the 1223 snap
on the new HW.

The messages kept repeating (I can get the full message - I am
not at that location now - tomorrow) and there was something
about MBOX command error 15. 

The isp0 messages went on ad nauseam, and no further control
could be regained at the console.

More details later.

Sven