Hello All,

I know it is an old story but....
I gave a chance to the latest snapshot I've find on releng.netbsd.org to
boot a Jensen. (DEC 2000 model 300)
Here is the result :(
It is the same lpt error that was mentioned in
http://mail-index.netbsd.org/port-alpha/2002/06/25/0000.html

Is there any hope that it will be fixed?

Thanks and regards,

//
Steve


_________________________
>>> b dka200
INIT-S-CPU...
AUDIT_BOOT_STARTS ...
AUDIT_CHECKSUM_GOOD
AUDIT_LOAD_BEGINS
AUDIT_LOAD_DONE


NetBSD/alpha 1.6K ustar Bootstrap, Revision 1.3
(autobuild@cs20.apochromatic.org, Fri Jan  3 06:51:50 UTC 2003)

VMS PAL rev: 0x100010530
OSF PAL rev: 0x20123
Switch to OSF PAL code succeeded.

Boot flags: 1
8226976+235504=0x812410

Entering netbsd at 0xfffffc00003012a0...
Unrecognized boot flag '1'.
[ netbsd ELF symbol table not valid ]
[ no symbol table formats found ]
Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003
    The NetBSD Foundation, Inc.  All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
    The Regents of the University of California.  All rights reserved.

NetBSD 1.6K (INSTALL) #0: Fri Jan  3 07:26:45 UTC 2003

autobuild@cs20.apochromatic.org:/autobuilder/build/HEAD/alpha/OBJ/autobuilde
r/build/HEAD/src/sys/arch/alpha/compile/INSTALL
DEC2000 model 300, 150MHz, s/n
8192 byte page size, 1 processor.
total memory = 128 MB
(2048 KB reserved for PROM, 126 MB used by NetBSD)
avail memory = 109 MB
using 819 buffers containing 6552 KB of memory
mainbus0 (root)
cpu0 at mainbus0: ID 0 (primary), 21064-0
cpu0: Architecture extensions: fffffc000062b030
jensenio0 at mainbus0
pckbc0 at jensenio0 port 0x60
com0 at jensenio0 port 0x3f8: ns8250 or ns16450, no fifo
com0: console
com0: interrupting at vector 0x900
com1 at jensenio0 port 0x2f8: ns8250 or ns16450, no fifo
com1: interrupting at vector 0x920
lpt0 at jensenio0 port 0x3bc
panic: scb_set: bad vector 0x1
Stopped in pid 0 (swapper) at   0xfffffc00005783a4:     ret     zero,(ra)
db>