On Mon, 21 Feb 2005 04:57:41 -0700, Andy Ruhl <acruhl@gmail.com> wrote:
> > Hm.. does ifconfig say that the interface is up?
> >
> > The problem may be that the phy needs some special handling, but apparently
> > there's no match for this phy. The OUI seems to be equal to the Matsushita
> > Electronics OUI, but I can't find anything on them manufacturing phys.
> >
> > You could experiment and replace MII_OUI_CICADA with 0x00c08f in
> > dev/mii/ciphy.c, so that it matches, and see if that works. It's
> > a long shot, but you never know until you try I guess.
> 
> I should have posted ifconfig output, but I'm 99% sure that it did say
> that the interface was up.
> 
> I'll give this a try.

Didn't work. I think the dmesg output is the same:

vge0 at pci0 dev 14 function 0: VIA VT612X Gigabit Ethernet (rev. 0x11)
vge0: interrupting at ioapic0 pin 22 (irq 10)
vge0: Ethernet address: 00:50:8d:ed:ac:29
ukphy0 at vge0 phy 1: Generic IEEE 802.3u media interface
ukphy0: OUI 0x00c08f, model 0x0021, rev. 2
ukphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT,
1000baseT-FDX, auto

Here's the ifconfig output for this card:

vge0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
        capabilities=7<IP4CSUM,TCP4CSUM,UDP4CSUM>
        enabled=0
        address: 00:50:8d:ed:ac:29
        media: Ethernet autoselect (100baseTX)
        status: active
        inet 192.168.1.1 netmask 0xffffff00 broadcast 192.168.1.255
        inet6 fe80::250:8dff:feed:ac29%vge0 prefixlen 64 scopeid 0x2

Problem was the same as before.

I can probably try again tonight or tomorrow morning if there are any
updates by then.

Andy