On Mon, Feb 21, 2005 at 05:57:18AM -0700, Andy Ruhl wrote:
> Didn't work. I think the dmesg output is the same:

Okay, can you please try disabling some alignment code, which I had
no chance to test and which might cause the problem?

Patch:
Index: if_vgevar.h
===================================================================
RCS file: /cvsroot/src/sys/dev/pci/if_vgevar.h,v
retrieving revision 1.1
diff -u -p -r1.1 if_vgevar.h
--- if_vgevar.h	20 Feb 2005 18:34:33 -0000	1.1
+++ if_vgevar.h	24 Feb 2005 14:35:27 -0000
@@ -32,9 +32,11 @@
  * $FreeBSD: src/sys/dev/vge/if_vgevar.h,v 1.2 2005/01/06 01:43:31 imp Exp $
  */
 
+#if 0
 #if !defined(__i386__)
 #define VGE_FIXUP_RX
 #endif
+#endif
 
 #define VGE_JUMBO_MTU	9000
 
> vge0 at pci0 dev 14 function 0: VIA VT612X Gigabit Ethernet (rev. 0x11)
> vge0: interrupting at ioapic0 pin 22 (irq 10)
> vge0: Ethernet address: 00:50:8d:ed:ac:29
> ukphy0 at vge0 phy 1: Generic IEEE 802.3u media interface
> ukphy0: OUI 0x00c08f, model 0x0021, rev. 2
> ukphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT,
> 1000baseT-FDX, auto
> 
> Here's the ifconfig output for this card:
> 
> vge0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
>         capabilities=7<IP4CSUM,TCP4CSUM,UDP4CSUM>
>         enabled=0
>         address: 00:50:8d:ed:ac:29
>         media: Ethernet autoselect (100baseTX)
>         status: active
>         inet 192.168.1.1 netmask 0xffffff00 broadcast 192.168.1.255
>         inet6 fe80::250:8dff:feed:ac29%vge0 prefixlen 64 scopeid 0x2
> 
> Problem was the same as before.
> 
> I can probably try again tonight or tomorrow morning if there are any
> updates by then.
> 
> Andy

-- 
Jaromir Dolecek <jdolecek@NetBSD.org>            http://www.NetBSD.cz/
-=- We can walk our road together if our goals are all the same;     -=-
-=- We can run alone and free if we pursue a different aim.          -=-