On Mon, 6 May 1996, Matt Harrell wrote:

> 	I tried using loadbsd with the synchronous SCSI mode off, and I
> still cannot get the NetBSD kernal to get past recognizing my hardware.  I
> also tried starting over from scratch with the 1.28GB SCSI disk removed
> from the system, and I used a SyQuestEZ135 disk for the BSD partitions,
> with the same results.  I've tried everything that I can think of to get
> 1.1 to load.  Does anyone have any ideas?  Is there anything else I need
> to know about preparing my hard disk for NetBSD other than what it says in
> the install doc?
> 	I think I am next going to try to install version 1.0 and see what
> happens. 
> 
> -----========++++++++++********************++++++++++========-----
>  Matt Harrell			Amiga 1200 running AmigaOS3.0
>  Lansing, MI U.S.A.		CSA 12 Gauge 030/882RC@50MHz/SCSI
>  mharrell@sojourn.com		2MB chip/18MB fast RAM
> 				240MB IDE hard disk
> 				1.28GB SCSI disk, SyquestEZ135S
> -----========++++++++++********************++++++++++========-----
> 

U must have done sth. wrong during installation...
Ive got similar hardware and everything works fine 
Just ftp the archive with NetBSD from ftp.luth.se
I got it run on my machine

gelo.

Hardware: a1200 , 68030, 68881 , 6mb fast, hdd 850 mb
Software: os3.0