After properly configuring the S4D1 switches, we (Joshua and I) got correct pci intr maps now.  Thanks a lot!
However, we still have the same db problem.
The ethernet doesn't work even without the PCI IDE controller.
And we run the evaluation board in Cyclone microsystems' 80300BP backplane.

-Justin

Allen Briggs <briggs@wasabisystems.com> said: 
> On Wed, Jun 25, 2003 at 07:30:07PM +0800, Jaw-Shiang Joshua Huang wrote:
> > The pci intr map seems wrong.
> 
> As Jason mentioned, this is due to the switch settings on the board.
> Reverse all four switches on S4D1 so that they are (from top to bottom)
> Right (off), Left, Right, Left.
> 
> > I want to boot NetBSD on Xscale and try to mount root on the disk
> > because the Xscale MB seems with a bad network controller.  In
> > Redboot prompt command, it cannot ping successfully, even ping itself.
> 
> Ouch.  Does the ethernet work OK without the PCI IDE controller in
> place?  Or does it fail the same way?  What are you running the board
> in?  A PC, or a backplane?
> 
> -allen
> 
> -- 
>  Allen Briggs                     briggs@wasabisystems.com
>  Wasabi Systems, Inc.             http://www.wasabisystems.com/
> 



--
Synology Inc.
25521814 ext 821
justind@synology.com