Neeraj Pal <neerajpal09%gmail.com@localhost> writes:
> So, I am installing -current in Raspberry Pi 3 by using the image,
> "evbarm-earmv7hf" and also this one, "evbarm-earmv6hf" from
> "http://nyftp.netbsd.org/pub/NetBSD-daily/HEAD/201806250640Z/";, but on
> both of the image serial console is not working. And, I did the same
> with FreeBSD just to verify the functioning of my USB-TTL and it is
> working fine with FreeBSD.
>
> And, I have also removed the framebuffer switching from cmdline.txt,
> but still it is not working.
>
> Then, I have downloaded the NetBSD-8 ("evbarm-earmv6hf") and then I
> found that serial console is working fine with NetBSD-8 image.
>
> Here, in NetBSD-8 also I need to remove the framebuffer switching line
> from cmdline.txt, after that everything works fine (only with
> NetBSD-8).
It sounds like you found a real problem.
I would try to complete the install using NetBSD 8, and set up
networking and sshd, and then swap in the current kernel and boot, and
see if you can ssh in and look at dmesg.
Attachment:
signature.asc
Description: PGP signature