Subject: Booting problem!
To: None <port-arm32@NetBSD.ORG>
From: Forbes Baylis <RiscBSD@trilong.demon.co.uk>
List: port-arm32
Date: 04/07/1997 23:54:25
I've been using RiscBSD successfully under RiscOS 3.5 and ARM610, but since
I upgraded to RiscOS 3.7 and StrongARM in my RiscPC it won't work. I've been
trying to boot from my internal IDE; wd0 (Quantum Sirocco 2.5GB) using the 
SA110-4958 kernel but after the initial start of the boot, when it gets to
the SCSI Card config I get a repeating scrolling message that fills up about 
10 screens!:-  sfasintr: SCSI-RESET detected!

followed by:

Using pcb_onfault=00002000 adress=00000400 st=1015500f curproc=f0131010

Prefetch address=00002000
Process=f0131010 pid=0 comm=
CPSR=60000013 Traceback info (frame=f0174fdc)
fp->lr=f01006b0 fp->PC=f010e99c
Trapframe PC=00002000
Trapframe SPSR=60000013
panic: Prefetch abort in SVC mode

stopped at _Debugger+0x10: ldmdb r11,{r11,r13,r15}

My SCSI card is the Cumana SCSI II interface.
I've tried SCSIFS Version 2.03 and 2.04 and am using SCSIMgr Version 2.59.
I've also tried playing with the SCSI card settings; Host ID, Boot timeout;
termination and bus resets, and disc settings; block trans mode, disconnects,
symc transfer mode etc etc, but nothing seems to work. I also tried using
the ARM610 card under RiscOS 3.7 but that didn't work either.

I've got 2x32MB simms and 2MB video ram and two SCSI discs; DEC RZ28 (2GB)
and a Micropolis (2.5GB) attached to the SCSI interface.

What am I doing wrong please, I need to get back into RiscBSD before I go
insane!