Hi Leo!

> No, 8Kb for all m68k NetBSD ports exept the hp300.
ok.

> > > Shouldn't I try something like 14 MB TT RAM (+2 MB ST RAM = 16 MB) then?
> > > Or 6 MB to get 8 MB in total? 
> No, I want to make sure your memory config is one I _know_ will work because
> I tried (and can try :-) ) it. That's why I proposed to 4MB TT ramsize
> setting to you. 
ok again...

> Maybe it is time to retreat your steps again. Otherwise there is a chance
> that we don't know what we are testing anymore.
> Let's start at the beginning...
> You have a TT with 2/20Mb ram, some SCSI devices and a 'normal' monitor :-(
> and nothing special attached.
Yep. And the 4 SCSI devices are detected perfectly. (beside the mode sense
problem with the MO-Drive)

TT-RAM is in 4*4 + 4*1 SIMMS on a MegTT-RAM-Card

> When boot it from floppy using 'loadbsd -b -T 4194304 netbsd' does
> this produce any problems? If it does not, I would propose to start
> the installation from here, so we at least know that it is installed
> properly.

I was able to install with 14 MB TT RAM... Will play this evening with
the installed stuff to check if 4 MB TT RAM works. (But I *think* I already
tested it and got strange errors again (about toggled bits in adresses,
you know from my previous mails).

Ciao for now, my courses begin soon... :-(
Benni
-- 
      ,,,, 
      /'^'\
     ( o o )
-oOOO--(_)--OOOo------------------------------------------------
  .oooO                           Benjamin Lorenz, Saarbruecken
  (   )   Oooo.               benni@phil.uni-sb.de, 0681/372253
---\ (----(   )-------------------------------------------------
    \_)    ) /
          (_/