As my P-133 seems to be (not so) slowly dying, I figured it was about time
to replace it, so I bought a SOYO SY-D6IBA motherboard (yes, it's dual-CPU,
but I've only got one PII-350 installed) with built-in AIC-7880.

Anyway, long story short, the install floppy won't complete a boot cycle if
the SCSI is enabled.  Under the 1.3.2 bootfloppy, it just reboots after
"scsibus0 at ahc1";  the bootfloppies from the 19990131 snapshot produce
this (hopefully I won't make any typos):

ahc1 at pci0 dev 11 function 0
ahc1: interrupting at irq5
ahc1: Using left over BIOS settings
ahc1: aic7880 Wide Channel, SCSI Id=7, 1 SCBs
scsibus0 at ahc1 channel 0: 16 targets, 8 luns per target
kernel: page fault trap, code=0
stopped in  at  _ahc_handle_seqint+0x1e70:	movl	0x24(%edi),%eax
db>


Any thoughts?


-- 
Jeff Rizzo                                         http://boogers.sf.ca.us/~riz