Hello,

I want to use a 3Com C589D with NetBSD 1.4.1
After commenting out most of the lines I get
The card fully identified as ep0, it uses 
irq 5. But I can only send packets (i.e.
erp-entry appears on the target host), but
I dont receive any. 

ep0 at pcmcia0 function 0 port 0x330-0x33f: 3Com 3c589 10Mbps Ethernet
ep0: address 00:10:4b:7d:bb:25, 8KB byte-wide FIFO, 5:3 Rx:Tx split
ep0: 10baseT, 10base5, 10base2 (default 10baseT)

Is what dmesg says. 

alternatively I moved the starting point of the IO-addresses to the 
same as windows says (the card works fine under windows)
to 0x1060. But with no success.

What else can I try? I had difficulties to compile current, it
did not resolve some symbols. 

Thank you!

Tino Wildenhain