On Fri, Dec 10, 1999 at 06:19:18PM +0100, Richard PLOIX wrote:
> [...]
> ahc1 at pci1 dev 11 function 0
> ahc1:
> interrupting at irq 10
> ahc1: aic7880 Wide Channel, SCSI Id=7, 16
> SCBs
> scsibus0 at ahc1 channel 0: 16 targets, 8 luns per target
> ahc1: target
> 0 synchronous at 10.0MHz, offset = 0xf
> sd0 at scsibus0 targ 0 lun 0:
> <SEAGATE, ST32550N, 0019> SCSI2 0/direct fixed
> sd0: 2047MB, 3511 cyl, 11
> head, 108 sec, 512 bytes/sect x 4194058 sectors
> ahc1: target 1 synchronous
> at 10.0MHz, offset = 0xf
> sd1 at scsibus0 targ 1 lun 0: <QUANTUM, FIREBALL
> SE8.4S, PJ0A> SCSI2 0/direct fixed
> sd1: 8191MB, 7637 cyl, 8 head, 274 sec,
> 512 bytes/sect x 16777215 sectors
> ahc1: board is not responding
> cmd
> fail
> probe(ahc1:5:0): timed out in datain phase, SCSISIGI ==
> 0x44
> probe(ahc1:5:0): asserted ATN - device reset in message buffer
> ahc1:
> board is not responding
> cmd fail
> sd2 at scsibus0 targ 5 lun 0: <, , > SCSI0
> 0/direct fixed
> ahc1: board is not responding
> ahc1: board is not
> responding
> sd2: mode sense (4) returned nonsense; using fictitious
> geometry
> ahc1: board is not responding
> cmd fail
> sd2: 40960MB, 40960 cyl, 64
> head, 32 sec, 512 bytes/sect x 83886081 sectors

There's a problem on your scsi bus, and because of this it seems that your
CD is detected as a fixed drive (sd2) here. Check cables, terminators,
etc, ...

--
Manuel Bouyer <bouyer@antioche.eu.org>
--