Here's what I see with the tlp driver and my FA310TX on -current (1.4P
/i386):

tlp1 at pci0 dev 11 function 0: Lite-On 82C169 Ethernet, pass 2.0
tlp1: interrupting at irq 15
tlp1: Ethernet address 00:a0:cc:57:a2:14
ukphy0 at tlp1 phy 1: Generic IEEE 802.3u media interface
ukphy0: OUI 0x001018, model 0x0021, rev. 2
ukphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto

Works just dandy at 100BaseTX.

Have you tried a more recent kernel to see if that changes anything?

    ScottE

----- Original Message -----
From: "Steven M. Bellovin" <smb@research.att.com>
To: <port-i386@netbsd.org>
Sent: Tuesday, December 14, 1999 7:51 PM
Subject: problems with NetGear FA-310TX card


> I recently got a NetGear FA-310TX 10/100 Ethernet card with a 82C169 chip
in
> it.  It works properly on Mr. Bill's (poor excuse for an) operating
system;
> NetBSD finds it, but can't seem to send or receive packets from it.  It's
> hooked to a 10BaseT hub; according to both ifconfig and the lights on the
> back, the card realizes that.  Manually setting it to 'media 10baseT'
hasn't
> helped.
>
> Any suggestions?  I'm running the Comdex snapshot; the board is found by
the
> tlp driver.
>
> --Steve Bellovin
>
>
>