! From: David Woyciesjes [mailto:david.woyciesjes@yale.edu]
! 
! 
! 	Did you check the full/half duplex setting also? Can the hub be
! configured, and locked (forced) to 10 MBit/half duplex? And 
! try locking A to
! 10/half also. 
! 	I've seen auto-negotiation (10/100 and full/half 
! duplex) flake out
! alot. Especially when wiring might be a problem... Of course, 
! I could be
! wrong, and the problem might be something else... :-)
! 
! ---   David A Woyciesjes


! -----Original Message-----
! From: Jon [mailto:jons@dotnet.com]
! 
! 
! thanks for the quick reponse, but no my hub can't be configured.
! 
! How do I correctly set a network card to be 10MBit????
! 
! Also Machine B is full duplex and Machine C is half duplex, 
! so either gives the same results BUT how do I set the 
! duplexing on the card too?
! 
! Thanks again
! 

Hmmm, I would make sure all the cards are set to half-duplex, and might as
well keep them all at 10 MBit, sincve only one is 100MBit card. Under
windows, you have to go to Network Properties, then the NIC card, then
'Advanced' properties...

---   David A Woyciesjes
---   C & IS Support Specialist
---   Yale University Press
---   mailto:david.woyciesjes@yale.edu
---   (203) 432-0953
---   ICQ # - 905818