Re: Installing NetBSD to an SD card on eBox

[Andrius V <vezhlys%gmail.com@localhost>]

Sorry to hear that it doesn't help. Likely as I last resort I would
play with acpi aware option (on/off) if such option exists for MX SoC,
or just try to boot without ACPI support (boot -2). Finally, if USB
installer boots successfully, you can consider an option to use USB
stick as your main drive. If you have a chance, please share dmesg
output (can be obtained from installer shell too (dmesg > dmesg.txt
and copied either through ssh or mounted in another netbsd system).
Thanks.

On Wed, Nov 2, 2022 at 6:23 AM Stanislav Syekirin
<stanislav.syekirin%studium.fernuni-hagen.de@localhost> wrote:
>
> Hi Andrius,
>
> thanks for the answer. Sadly, I get the error both with native mode
> and legacy mode. The power adapter is the original one, so I've been
> told. I don't have a full size SD card, but I've tested the card
> adapter and the microSD card by booting the OpenBSD installer from it
> (and installing successfully to a different card; so I have a working
> system now, it's just that I would have slightly preferred NetBSD),
> and also by booting Gentoo from another card and verifying with lsblk
> that it sees the disk (I didn't proceed with the installation due to
> lack of time and experience). Earlier, I also was able to reproduce
> almost the same error message with the OpenBSD install disk (maybe the
> line breaks and a few other details were a bit different), but I
> didn't write the BIOS settings down, and the error disappeared after
> resetting to optimal defaults.
>
> Regards
> Stanislav
>
> On Mo, 31 Okt 2022 20:24:18 +0200
>   Andrius V <vezhlys%gmail.com@localhost> wrote:
> > Hi,
> >
> >> 'wd0d: device timeout reading fsbn 0 (wd0 bn 0; cn 0 tn 0 sn 0),
> >> retrying'
> >> rdcide0:0:0: lost interrupt
> >>         type: ata tc_bcount: 512 tc_skip: 0
> >>
> >
> > Regarding this error, you may try to switch IDE mode from native to
> > legacy in BIOS. It helps on my Vortex86DX3 platform. Reliability
> > problems can be also related to either not enough power (wouldn't
> > recommend to power it from another USB port, better to use USB power
> > adapter) or SD card itself (better to use full size SD card instead
> >of
> > microSD with adapter). However, I don't have MX based eBox, thus
> > problems can be platform related...
> >
> > Regards,
> > Andrius V
>