I have downloaded  the 1.1 snap off puma.bevd.blacksburg.va.us and 
installed it on an my Powerbook 150 on an external 40MB. The 
installation seemed to work OK, other than an occasional 
un-implemented instruction error (I re-booted and started the 
installation again).

Using booted 1.8 I get plenty of unix type booting messages (looks 
great up till now) then it  clears screen and :

[ preserving 89324 bytes of netbsd symbol table ]
Bootstrapping NetBSD/mac68k.
Getting mapping from MMU.

And there is hangs !!!! 

Now, I am assuming that the Powerbook 150 has no FPU and that this is 
an FPU related problem (excuse my ignorance but is an MMU the same 
an FPU ?????)

Please excuse my ignorance but although I use Net/FreeBSD on pc's and 
am playing with Linux/MIPS I am not quite up to speed on the Mac and 
any guidance would be grately appreciated.

I remember the last time I tried to use NetBSD/mac68k I didn't get 
past a telling me it was out of  'Miracle Whip and Oreos' so I 
suppose this is an improvement ?????

Cheers


Phil