Hello. I recently set up NetBSD and X on an SE30, and everything went
without a hitch. I want to set up the ethernet card in it. At boot, I get
the following messages:
---
Unknown ethernet drsw: 10b
nubus0: slot 9: DaynaPORT E/si30 (Vendor: Dayna Communications, Part:
DaynaPORT_E/si30) not configured
---
I know it's not configured - that's the problem. I haven't seen that much
info on setting up third party ethernet cards w/ NetBSD. Can someone point
in the direction of some info or instructions on setting up this ethernet
card (if it is supported)?

TIA,

Nat Fellows