I just finished loading 1.4 on to a PowerBook 540c and it is hanging 
during boot. I have tried booting in B&W and 256 color mode (I am happy 
to see the Kayboard is recognized!) as well as booting single and 
multi-user mode.

Any ideas?

SYSTEM: PB540c, 32megs RAM, 310megs hd dedicated to Root & User single 
parition.

NetBSD 1.4 (GENERIC) #0: Sat May 8 20:52:59 PDT 1999
     root2@c610:/usr/src/sys/arch/mac68k/compile/GENERIC
Apple Macintosh PowerBook 500 (68040)
cpu: delay factor 296
real mem = 37748736
avail mem = 31633408
using 486 buffers containing 1990656 bytes of memory
mrg: '68040 PowerBook ROMs' ROM glue, tracing off, debug off, silent traps
mrg: I/O map kludge for ROMs that use hardware addresses directly.
mainbus0 (root)
obio0 at mainbus0
adb0 at obio0 (direct, PowerBook): 2 targets
aed0 at adb0 addr 0: ADB Event device
kbd0 at adb0 addr 2: PowerBook extended keyboard
ms0 at adb0 addr 3: Logitech MouseMan (non-EMP) mouse
asc0 at obio0: Apple Sound Chip
intvid0 at obio0 @ 60000000: On-board video
intvid0: 640 x 480, monochrome
grf0 at intvid0
ite0 at grf0 (minimal console)
sn0 at obio0: failed to get MAC address.
iwm0 at obio0: Apple GCR floppy disk controller
iwm: Chip revision not supported (-77)
ncrscsi0 at obio0
scsibus0 at ncrscsi0: 8 targets, 8 luns per target
sd0 at scsibus0 targ 0 lun 0: (IBM, H2344-S4C, S6A0) SCSI1 0/direct fixed
sd0: 328MB, 2262 cyl, 4 head, 74 sec, 512 bytes/sect x 672525 sectors
zsc0 at obio0 chip type 0
zsc0 channel 0: d_speed  9600 DCD clk 0 CTS clk 0
zstty0 at zsc0 channel 0
zsc0 channel 1: d_speed  9600 DCD clk 0 CTS clk 0
zstty1 at zsc0 channel 1
nubus0 at mainbus0
fpu0 at mainbus0 (emulator)
boot device: sd0
root on sd0a dumps on sd0b
*HANG*

---
Sean J. Schluntz                           schluntz@agames.com
Sr. Office Systems Administrator                  408-434-5804
Atari Games Corporation                  http://www.agames.com

Mountain Dew and doughnuts...because breakfast is the most 
important meal of the day. - ???