The etherwave isn't two separate NIC's; the second port is or daisy-chaining
without using a hub. I remember when using one of these with Windows NT, it
appears as a 3COM 3C509 using thin coax, rather than the UTP interface, but
worked just fine that way.

-- 
Craig R. Arko
About Computing...
Tel: 612-379-0174
Email: crarko@aboutcomp.com
URL: www.aboutcomp.com


> From: Daniel Parks <danielparks@bigfoot.com>
> Date: Wed, 26 Jul 2000 23:16:29 -0700
> To: NetBSD-mac68k list <port-mac68k@netbsd.org>
> Subject: Farallon Nubus EtherWave with 2 RJ-45 jacks
> 
> I just bought a Quadra 650 and installed NetBSD on it... I used a firewall
> setup I found on http://users.erols.com/ewinkler/ .
> 
> I put a Farallon Nubus EtherWave card (with 2 RJ-45 jacks) in it, and set
> ifconfig.ae0 to have an IP address of 192.168.1.1 and ifconfig.ae1 to some
> other IP address. However, the second RJ-45 jack is not recognized as ae1
> or anything else. The entire card is ae0.
> 
> Unfortunately, it doesn't  seem to work at all. When I put an ethernet
> cable in ether jack, and try to ping my Mac or ssh/telnet/ftp/http in from
> the Mac, it doesn't work.
> 
> On the other hand, changing ifconfig.ae0 to ifconfig.sn0 and using the AAUI
> port does work... I can access the Quadra.
> 
> Any ideas?
> 
> Thanks in advance,
> Daniel Parks
> 
>