It is th st341200

http://www.sunshack.org/data/feh/1.1/wcd00004/wcd0044d.htm

I have problems with ...

What is the setting of the J2 jumpers:

Which in/out ??  The disk is inside the mac LC III.

here is the list:


J2*
PIN		SETTING 	DESCRIPTION
TP 		Out 		Drive does not supply TERMPWR to the SCSI bus
TP 		Out 		Drive does not supply TERMPWR to itself
TE 		Out 		Terminators enabled
PE 		In 			Parity enabled
WP 	Out 		Write protect disabled
ME 	In 			Motor start enabled upon Start Unit command
DS 		Out 		Motor start delay = 16 times drive ID
SS 		Out 		Reserved


Op 7-jan-06 om 03:30 heeft William Duke het volgende geschreven:

> I couldn't get the link you provided to work.  What is the Hawk 
> 31200N?  Is
> that a hard drive?
>
> Regards,
>
>
>> From: Marc Coevoet <marcsje@fulladsl.be>
>> Date: Fri, 6 Jan 2006 08:14:16 +0100
>> To: port-mac68k@NetBSD.org
>> Subject: isntall succeed ?, probs with /sbin/init/ SCSI jumper 
>> settings
>>
>> I can see the LCIII boot, but it then complains about date (ok, set to
>> 0 or ?? 1956) and it does not find /sbin/init...
>>
>> I think I have a prob with jumpers of the Hawk 31200N: (it does not
>> mount properly, although I could install ..)
>>
>> http://www.ciprico.com/pdf_csTech/21020535.pdf
>>
>> How do I need to set the switches ??
>>
>> The Hawk is inside the mac, scsi id 0
>>
>> Marc
>>
>