I mount in =3Dmnt
I put in sysinst as download dir:
/mnt/targetroot/usr/INSTALL

it STILL says device full ???

Still writing to ramdisk ???

What do I need to do ??

Make a download dir that EXISTS ??

Marc


Op 8-jan-06 om 12:50 heeft Marco Trillo het volgende geschreven:

> Hi,
>
> It depends on your disklabel, but it is normally:
>
> /dev/sd0a --> root (/)
> /dev/sd0b --> swap
> /dev/sd0g --> user (/usr)
>
> Are you using the 3.0 release?
> Its sysinst-based installer is currently broken. As an example, it=20
> does not write a valid /etc/fstab file.
>
> I recommend booting the INSTALL kernel, opening a shell, and writing a=20=

> valid /etc/fstab.
>
> # Mount the root device
> $ mount /dev/sd0a /mnt && cd /mnt
> $ cat > etc/fstab
> # fstab example for the above scheme
> /dev/sd0a / ffs rw 1 1
> /dev/sd0b none swap sw 0 0
> /dev/sd0g /usr ffs rw 1 2
> ^D
> $ cd /
> $ umount /mnt
> $ exit
>
> Of course you should write a fstab according to your disk.
> I.e.; if you have a partition /dev/sd0e which should be mounted in=20
> /home,
>
> /dev/sd0e /home ffs rw 1 2
>
> If you don`t remeber the mount points of each partition, you can use=20=

> the "Install NetBSD to hard disk" to see the partition table and then=20=

> abort the installation.
>
> --
> Marco.
>
>
> On Jan 8, 2006, at 10:19 AM, Raw Power wrote:
>
>> the root&usr is on the fifth partition.
>>
>> =CCS
>> that  /dev/sda5  or /dev/sd0e   ??
>>
>> The booting process reads & execs kernel, then
>> says
>> booting from /dev/sd0a, swap on /dv/sd0b   ...
>>
>> Marc
>