tlp: driver not supported in NetBSD 6.0?

[Donald Lee <MacPPC2%caution.icompute.com@localhost>]

Hi,

I am upgrading my server to either NetBSD 5.2 or 6.0.1, and I find that when
I load up 6.0.1, the network doesn't work.  In the log, it says something
about "sorry, I cn't handle your board".  (unfortunately, I already wiped the
disk with the message, but it was something like that.)

For now, this problem is a killer for 6.0, and 5.2 looks like it will
work fine, so I think I will go with 5.2 for now.

Question: Has anyone else noticed the failure of the tlp driver in
6.0?

My dmesg is below (when booting 5.2)

Thanks,

-dgl-



Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005,
    2006, 2007, 2008, 2009
    The NetBSD Foundation, Inc.  All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
    The Regents of the University of California.  All rights reserved.

NetBSD 5.0.2 (GENERIC) #0: Sat Feb  6 18:57:33 UTC 2010
        
builds%b8.netbsd.org@localhost:/home/builds/ab/netbsd-5-0-2-RELEASE/macppc/201002061851Z-obj/home/builds/ab/netbsd-5-0-2-RELEASE/src/sys/arch/macppc/compile/GENERIC
total memory = 640 MB
avail memory = 608 MB
timecounter: Timecounters tick every 10.000 msec
found openpic PIC at 80040000
OpenPIC Version 1.2: Supports 4 CPUs and 64 interrupt sources.
bootpath: /pci@f2000000/@d/mac-io@7/ata-4@1f000/disk@0:0/netbsd
mainbus0 (root)
cpu0 at mainbus0: 7400 (Revision 2.6), ID 0 (primary)
cpu0: HID0 8094c0a4<EMCP,DOZE,DPM,EIEC,ICE,DCE,SGE,BTIC,BHT>, powersave: 1
cpu0: 450.00 MHz, no-parity 1MB WB L2 cache (PB SRAM) at 2:1 ratio
memory0 at mainbus0: len=512
spdmem0 at memory0
spdmem0: SDRAM memory, no parity or ECC, 128MB, 100MHz (PC-800)
spdmem0: 12 rows, 9 cols, 2 banks, 4 banks/chip, 10.0ns cycle time
spdmem0: tAA-tRCD-tRP-tRAS: 3-20-20-50
spdmem0: voltage LvTTL (not 5V tolerant), refresh time 15.625us 
(self-refreshing)
spdmem1 at memory0
spdmem1: SDRAM memory, no parity or ECC, 128MB, 125MHz (PC-1000)
spdmem1: 12 rows, 10 cols, 1 banks, 4 banks/chip, 8.0ns cycle time
spdmem1: tAA-tRCD-tRP-tRAS: 3-20-20-50
spdmem1: voltage LvTTL (not 5V tolerant), refresh time 15.625us 
(self-refreshing)
spdmem2 at memory0
spdmem2: SDRAM memory, no parity or ECC, 128MB, 125MHz (PC-1000)
spdmem2: 12 rows, 10 cols, 1 banks, 4 banks/chip, 8.0ns cycle time
spdmem2: tAA-tRCD-tRP-tRAS: 3-20-20-50
spdmem2: voltage LvTTL (not 5V tolerant), refresh time 15.625us 
(self-refreshing)
spdmem3 at memory0
spdmem3: SDRAM memory, no parity or ECC, 256MB, 125MHz (PC-1000)
spdmem3: 13 rows, 10 cols, 1 banks, 4 banks/chip, 8.0ns cycle time
spdmem3: tAA-tRCD-tRP-tRAS: 3-20-20-48
spdmem3: voltage LvTTL (not 5V tolerant), refresh time 7.8us (self-refreshing)
uni_n0 at mainbus0 address 0xf8000000
ki2c0 at uni_n0 address 0xf8001000
iic1 at ki2c0: I2C bus
uninorth0 at mainbus0
pci0 at uninorth0 bus 0
pci0: i/o space, memory space enabled
pchb0 at pci0 dev 11 function 0
pchb0: Apple Computer UniNorth AGP Interface (rev. 0x00)
genfb0 at pci0 dev 16 function 0: ATI Technologies Rage 128 GL AGP 2x
genfb0: framebuffer at 0x94008000, size 1152x870, depth 8, stride 1280
wsdisplay0 at genfb0 kbdmux 1: console (default, vt100 emulation)
wsmux1: connecting to wsdisplay0
drm at genfb0 not configured
uninorth1 at mainbus0
pci1 at uninorth1 bus 0
pci1: i/o space, memory space enabled
pchb1 at pci1 dev 11 function 0
pchb1: Apple Computer UniNorth Host-PCI Bridge (rev. 0x00)
ppb0 at pci1 dev 13 function 0: Digital Equipment DC21154 PCI-PCI Bridge (rev. 
0x05)
pci2 at ppb0 bus 1
pci2: i/o space, memory space enabled
obio0 at pci2 dev 7 function 0: addr 0x80000000
obio0: enabling KeyLargo internal modem
zsc0 at obio0 irq 22,50
zstty0 at zsc0 channel 0
zstty1 at zsc0 channel 1
davbus at obio0 offset 0x14000 not configured
pmu0 at obio0 offset 0x16000 irq 47:  rev. 12
pmu0: initializing RTC
pmu0: power-mgt not configured
ki2c1 at obio0
iic2 at ki2c1: I2C bus
wdc0 at obio0 offset 0x1f000 irq 19, level triggered: DMA transfer
atabus0 at wdc0 channel 0
wdc1 at obio0 offset 0x20000 irq 20, level triggered: DMA transfer
atabus1 at wdc1 channel 0
wdc2 at obio0 offset 0x21000 irq 21, level triggered: DMA transfer
atabus2 at wdc2 channel 0
ohci0 at pci2 dev 8 function 0: Apple Computer KeyLargo USB Controller (rev. 
0x00)
ohci0: interrupting at irq 27
ohci0: OHCI version 1.0
usb0 at ohci0: USB revision 1.0
ohci1 at pci2 dev 9 function 0: Apple Computer KeyLargo USB Controller (rev. 
0x00)
ohci1: interrupting at irq 28
ohci1: OHCI version 1.0
usb1 at ohci1: USB revision 1.0
fwohci0 at pci2 dev 10 function 0: Texas Instruments TSB12LV23 IEEE 1394 Host 
Controller (rev. 0x00)
fwohci0: interrupting at irq 63
fwohci0: OHCI version 1.0 (ROM=0)
fwohci0: No. of Isochronous channels is 4.
fwohci0: EUI64 00:0a:27:ff:fe:7a:bd:2c
fwohci0: Phy 1394a available S400, 3 ports.
fwohci0: Link S400, max_rec 2048 bytes.
ieee1394if0 at fwohci0: IEEE1394 bus
fwip0 at ieee1394if0: IP over IEEE1394
fwohci0: Initiate bus reset
tlp0 at pci2 dev 11 function 0: DECchip 21143 Ethernet, pass 4.1
tlp0: interrupting at irq 58
tlp0: Ethernet address 00:0a:27:7a:bd:2c
bmtphy0 at tlp0 phy 0: BCM5201 10/100 media interface, rev. 2
bmtphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
uninorth2 at mainbus0
pci3 at uninorth2 bus 0
pci3: i/o space, memory space enabled
pchb2 at pci3 dev 11 function 0
pchb2: Apple Computer UniNorth Host-PCI Bridge (rev. 0x00)
biomask 80007fe netmask 80007fe ttymask 80007fe
timecounter: Timecounter "clockinterrupt" frequency 100 Hz quality 0
timecounter: Timecounter "mftb" frequency 24907667 Hz quality 100
fwohci0: BUS reset
fwohci0: node_id=0xc800ffc0, gen=1, CYCLEMASTER mode
ieee1394if0: 1 nodes, maxhop <= 0, cable IRM = 0 (me)
ieee1394if0: bus manager 0 (me)
uhub0 at usb0: Apple Computer OHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
uhub1 at usb1: Apple Computer OHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub1: 2 ports with 2 removable, self powered
wd0 at atabus0 drive 0: <ST380023A>
wd0: drive supports 16-sector PIO transfers, LBA addressing
wd0: 76319 MB, 155061 cyl, 16 head, 63 sec, 512 bytes/sect x 156301488 sectors
wd0: drive supports PIO mode 4, DMA mode 2, Ultra-DMA mode 5 (Ultra/100)
wd1 at atabus0 drive 1: <ST380011A>
wd1: drive supports 16-sector PIO transfers, LBA48 addressing
wd1: 76319 MB, 155061 cyl, 16 head, 63 sec, 512 bytes/sect x 156301488 sectors
wd1: drive supports PIO mode 4, DMA mode 2, Ultra-DMA mode 5 (Ultra/100)
wd0(wdc0:0:0): using PIO mode 4, DMA mode 2, Ultra-DMA mode 4 (Ultra/66) (using 
DMA)
wd1(wdc0:0:1): using PIO mode 4, DMA mode 2, Ultra-DMA mode 4 (Ultra/66) (using 
DMA)
atapibus0 at atabus1: 2 targets
cd0 at atapibus0 drive 0: <PIONEER DVD-RW  DVR-115D, HCDP810774WL, 1.18> cdrom 
removable
cd0: drive supports PIO mode 4, DMA mode 2, Ultra-DMA mode 4 (Ultra/66)
cd0(wdc1:0:0): using PIO mode 4, DMA mode 2 (using DMA)
uhub2 at uhub1 port 1: Mitsumi Electric Hub in Apple Extended USB Keyboard, 
class 9/0, rev 1.10/4.20, addr 2
uhub2: 3 ports with 2 removable, bus powered
uhidev0 at uhub2 port 1 configuration 1 interface 0
uhidev0: Fujitsu Component Apple Optical USB Mouse, rev 1.10/1.00, addr 3, 
iclass 3/1
ums0 at uhidev0: 1 button
wsmouse0 at ums0 mux 0
uhidev1 at uhub2 port 3 configuration 1 interface 0
uhidev1: Mitsumi Electric Apple Extended USB Keyboard, rev 1.10/4.20, addr 4, 
iclass 3/1
ukbd0 at uhidev1
wskbd0 at ukbd0: console keyboard, using wsdisplay0
uhidev2 at uhub2 port 3 configuration 1 interface 1
uhidev2: Mitsumi Electric Apple Extended USB Keyboard, rev 1.10/4.20, addr 4, 
iclass 3/0
uhidev2: 3 report ids
uhid0 at uhidev2 reportid 2: input=1, output=0, feature=0
uhid1 at uhidev2 reportid 3: input=3, output=0, feature=0
Kernelized RAIDframe activated
boot device: wd0
root on wd0a dumps on wd0b
root file system type: ffs
Accounting started