Re: Ralink RT305x NetBSD

[Ryo Shimizu <ryo%nerv.org@localhost>]

>I learned that NetBSD CVS tree now has Ralink RT305x Soc
>support.  Does anyone out there have recommendations to
>run NetBSD on Ralink products?  320MHz 32K/16K cache
>MIPS core is a good vehicle to stick on.  Hack friendly, easy
>to go products are welcome.

Im trying to run NetBSD on Fonera FON2405E.
but this board has no console, so we need serial cable hack. (e.g. MAX232C)

   http://www.nerv.org/~ryo/d/img/FON2405E_007.jpg

power on with pressing microswitch, I could enter U-boot prompt menu.
this board is very cheap and hack friendly :-)

        U-Boot 1.1.3 (Jan  6 2010 - 07:10:30)
        RT3052 # tftp 80010000 netbsd.bin
        
         netboot_common, argc= 3 
        
         NetTxPacket = 0x81FE4DC0 
        Trying Eth0 (10/100-M)
        
         ETH_STATE_ACTIVE!! 
        Using Eth0 (10/100-M) device
        TFTP from server 10.10.10.3; our IP address is 10.10.10.200
        Filename 'netbsd.bin'.
        
         TIMEOUT_COUNT=10,Load address: 0x80010000
        Loading: Got ARP REPLY, set server/gtwy eth addr (00:02:2a:dd:58:24)
        Got it
        T #
         first block received  
        ################################################################
               #################################################################
               #################################################################
               #################################################################
               #################################################################
               #################################################################
               #################################################################
               #################################################################
               #################################################################
               #############
        done
        Bytes transferred = 3059056 (2ead70 hex)
        NetBootFileXferSize= 002ead70
        RT3052 # go 80010000
        ## Starting application at 0x80010000 ...
        Enabled early console
        pmap_steal_memory: seg 0: 0x3 0x3 0x10 0x10
        pmap_steal_memory: seg 0: too small for 142 pages
        pmap_steal_memory: seg 1: 0x339 0x339 0x1fff 0x1fff
        Loaded initial symtab at 0x80288610, strtab at 0x802b11cc, # entries 
9799
        Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 
2005,
            2006, 2007, 2008, 2009, 2010, 2011
            The NetBSD Foundation, Inc.  All rights reserved.
        Copyright (c) 1982, 1986, 1989, 1991, 1993
            The Regents of the University of California.  All rights reserved.
        
        NetBSD 5.99.56 (RT3050) #0: Wed Oct 12 21:01:51 JST 2011
              ryo@moveq:/src/cvs/NetBSD/sys/arch/evbmips/compile/RT3050
        total memory = 32768 KB
        avail memory = 28856 KB
        mainbus0 (root): Ralink System Bus
        cpu0 at mainbus0: 320.00MHz (hz cycles = 1600000, delay divisor = 160)
        cpu0: MIPS 24KE (0x1964c) Rev. 76 with software emulated floating point
        cpu0: 32 TLB entries, 256MB max page size
        cpu0: 32KB/32B 4-way set-associative L1 instruction cache
        cpu0: 16KB/32B 4-way set-associative write-back L1 data cache
        rwdog0 at mainbus0: Ralink watchdog controller
        rwdog0: max period 40 sec.
        rwdog0: KTICKLE mode, period -30 sec.
        rgpio0 at mainbus0: Ralink GPIO controller
        gpio0 at rgpio0: 98 pins
        ri2c0 at mainbus0: Ralink I2C controller
        iic0 at ri2c0: I2C bus
        com0 at mainbus0: Au1X00 UART, working fifo
        com0: console
        ehci0 at mainbus0: EHCI USB controller
        usb0 at ehci0: USB revision 2.0
        reth0 at mainbus0: Ralink Ethernet
        cfi unconfigured
        uhub0 at usb0: Ralink EHCI root hub, class 9/0, rev 2.00/1.00, addr 1
        usb0: root device is not a hub
        root device: reth0
        dump device: 
        file system (default generic): 
        root on reth0
        mountroot: trying nfs...
        nfs_boot: trying DHCP/BOOTP
        nfs_boot: timeout...
        nfs_boot: timeout...
        nfs_boot: timeout...
        nfs_boot: trying RARP (and RPC/bootparam)
        revarp failed, error=51
        mountroot: trying msdos...
        mountroot: trying ffs...
        Supported file systems: tmpfs procfs nfs msdos mfs kernfs ffs
        no file system for reth0
        cannot mount root, error = 79
        root device (default reth0): 

--
ryo shimizu