I have a few questions on disklabel...  The first is about the files 
needed.  The instruction page says that you need miniroot, bootrz and 
rzboot (those last two names may be wrong, but there are two of them).  
The problem is, I can't find them.  I did find rz2netbsd.aout that seems 
to be one of the files, but where is the other one?

  Also, I think this is the write data file for disklabel (320MB drive), 
but it seems wrong...  if you notice anything, please tell me.

# Sample disk label prototype file for RZ25.   Note the outrageously bogus
# cylinder size - one block per cylinder.   It may be better to put legitimate
# numbers in here, but be sure that if you do, the size of the c partition
# adds up to sectors/track * tracks/cylinder * cylinders.
type: SCSI
disk: rs2
label: 
flags:
bytes/sector: 512
sectors/track: 1
tracks/cylinder: 1
sectors/cylinder: 1
cylinders: 655360
rpm: 3600
interleave: 1
trackskew: 0
cylinderskew: 0
headswitch: 0           # milliseconds
track-to-track seek: 0  # milliseconds
drivedata: 0 
 
4 partitions:
#        size   offset    fstype   [fsize bsize   cpg]
  a:   614400        0    4.2BSD     1024  8192    16   # 300MB
  b:    40960   614401      swap                        # 20MB


Matthew Orgass
darkstar@skypoint.com