On 18 Oct 1998, Simon Burge wrote:

> On Sat, 17 Oct 1998 22:07:06 +0200 (MET DST)  Richard van den Berg wrote:
> 
> > Use the clear-NVR jumper described in "Personal DECstation 5000 Hardware
> > Maintenance Guide" 

This is a Personal DECstation 5000/xx Guide.

> > o First locate the two-pin nvr connector, if you're in front of the
> > machine it's located left from the power connecter and marked "nvr".
			 ^^^^
Right for a 5000/1xx

> > o Slide a jumper over the nvr connector.
> > 
> > o Turn on the system power and wait for the console prompt to appear.
> > 
> > o When the console prompt appears, turn off the system power again.
> > 
> > o Remove the jumper from the nvr connector.
> > 
> > And you should be ready to go.
> 
> Another one for the FAQ...
> 
> I know that the 5000/2[46]0 has an NVR jumper - it seems the Personal
> DECstation does too.  Does anyone know any other models that have
> this jumper?  I can also check the /200 and /1xx when I get to work
> tomorrow...

Description is for a Personal DECstation 5000/xx, and except the location
of the jumper is the same for a 5000/1xx.

Regards,
Richard