Re: pciide0:0:0: lost interrupt

[Allen Briggs <briggs%wasabisystems.com@localhost>]

On Tue, May 07, 2002 at 02:25:21PM +0900, Boo Geum Jung wrote:
> I found pciide supprt at current version (2002/04).
> So I attached IDE disk, but something goes wrong.
> The following error message occurred.
> 
> Is there some problem yet in IDE Disk control?

Yes.  I think that the pciide is not getting fully initialized.  On
other systems, the firmware may be doing some initialization that
DINK is not performing.  I haven't had a chance to dig into that yet.

-allen

-- 
 Allen Briggs                     briggs%wasabisystems.com@localhost
 http://www.wasabisystems.com/    Quality NetBSD CDs, Sales, Support, Service
NetBSD development for Alpha, ARM, M68K, MIPS, PowerPC, SuperH, XScale, etc...