QNAP TS-201 success

[Julian Coleman <jdc%coris.org.uk@localhost>]

Hi,

Just to let you know that I installed 6.0 beta2 without any problems on a
QNAP TS-201.  I booted with NFS root, set up the disks, unpacked the sets
manually, and installed altboot.  This was very simple to do by following
the installation guide.  I did forget to run MAKEDEV, so I've added raid0
to the init) section of MAKEDEV.conf, in case someone else forgets too:

  src/etc/etc.sandpoint/MAKEDEV.conf    r1.15
  http://mail-index.NetBSD.org/source-changes/2012/06/21/msg035145.html

dmesg appended.

Thanks for all the work that made it a very easy install!

J

  - - 8< - - - - - - - - - - - - - Cut here - - - - - - - - - - - - - >8 - -
NetBSD 6.0_BETA2 (GENERIC) #1: Wed Jun  6 16:29:36 UTC 2012
        
root%orion.coris.org.uk@localhost:/usr/obj/sandpoint/usr/cvs/netbsd-6/src/sys/arch/sandpoint/compile/GENERIC
Model: qnap
total memory = 128 MB
avail memory = 119 MB
OpenPIC Version 1.2: Supports 1 CPUs and 26 interrupt sources.
timecounter: Timecounters tick every 10.000 msec
mainbus0 (root)
cpu0 at mainbus0: 8245 (Revision 0.4), ID 0 (primary)
cpu0: HID0 0x90c000<DOZE,DPM,ICE,DCE>, powersave: 1
cpu0: 265.31 MHz
eumb0 at mainbus0
com0 at eumb0 unit 0: ns16550a, working fifo
com0: console
com0: interrupting at irq 40
ociic0 at eumb0
iic0 at ociic0: I2C bus
s390rtc0 at iic0 addr 0x30: Seiko Instruments 35390A Real-time Clock
satmgr0 at eumb0 unit 1: button manager (qnap)
satmgr0: interrupting at irq 41
cfi at mainbus0 not configured
pci0 at mainbus0 bus 0
pci0: i/o space, memory space enabled
pchb0 at pci0 dev 0 function 0
pchb0: vendor 0x1057 product 0x0006 (rev. 0x14)
satalink0 at pci0 dev 13 function 0: Silicon Image SATALink 3512 (rev. 0x01)
satalink0: SATALink BA5 register space disabled
satalink0: bus-master DMA support present
satalink0: primary channel wired to native-PCI mode
satalink0: using irq 16 for native-PCI interrupt
atabus0 at satalink0 channel 0
satalink0: secondary channel wired to native-PCI mode
atabus1 at satalink0 channel 1
ohci0 at pci0 dev 14 function 0: vendor 0x1033 product 0x0035 (rev. 0x43)
ohci0: interrupting at irq 17
ohci0: OHCI version 1.0
usb0 at ohci0: USB revision 1.0
ohci1 at pci0 dev 14 function 1: vendor 0x1033 product 0x0035 (rev. 0x43)
ohci1: interrupting at irq 17
ohci1: OHCI version 1.0
usb1 at ohci1: USB revision 1.0
ehci0 at pci0 dev 14 function 2: vendor 0x1033 product 0x00e0 (rev. 0x04)
ehci0: interrupting at irq 17
ehci0: EHCI version 1.0
ehci0: companion controllers, 3 ports each: ohci0 ohci1
usb2 at ehci0: USB revision 2.0
re0 at pci0 dev 15 function 0: RealTek 8169SC/8110SC Single-chip Gigabit 
Ethernet (rev. 0x10)
re0: interrupting at irq 18
re0: Ethernet address 00:e0:4c:69:20:01
re0: using 256 tx descriptors
rgephy0 at re0 phy 7: RTL8169S/8110S/8211 1000BASE-T media interface, rev. 2
rgephy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT, 
1000baseT-FDX, auto
biomask 1c000000 netmask 1c000000 ttymask 1c000000
timecounter: Timecounter "clockinterrupt" frequency 100 Hz quality 0
timecounter: Timecounter "mftb" frequency 33164691 Hz quality 100
satalink0: port 0: device present, speed: 1.5Gb/s
satalink0: port 1: device present, speed: 1.5Gb/s
wd0 at atabus0 drive 0
wd0: <ST3500418AS>
wd0: drive supports 16-sector PIO transfers, LBA48 addressing
wd0: 465 GB, 969021 cyl, 16 head, 63 sec, 512 bytes/sect x 976773168 sectors
uhub0 at usb0: vendor 0x1033 OHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 3 ports with 3 removable, self powered
uhub1 at usb1: vendor 0x1033 OHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub1: 2 ports with 2 removable, self powered
uhub2 at usb2: vendor 0x1033 EHCI root hub, class 9/0, rev 2.00/1.00, addr 1
uhub2: 5 ports with 5 removable, self powered
IPsec: Initialized Security Association Processing.
wd0: drive supports PIO mode 4, DMA mode 2, Ultra-DMA mode 6 (Ultra/133)
wd0(satalink0:0:0): using PIO mode 4, Ultra-DMA mode 6 (Ultra/133) (using DMA)
wd1 at atabus1 drive 0
wd1: <ST3500418AS>
wd1: drive supports 16-sector PIO transfers, LBA48 addressing
wd1: 465 GB, 969021 cyl, 16 head, 63 sec, 512 bytes/sect x 976773168 sectors
wd1: drive supports PIO mode 4, DMA mode 2, Ultra-DMA mode 6 (Ultra/133)
wd1(satalink0:1:0): using PIO mode 4, Ultra-DMA mode 6 (Ultra/133) (using DMA)
Kernelized RAIDframe activated
raid0: RAID Level 1
raid0: Components: /dev/wd0a /dev/wd1a
raid0: Total Sectors: 976772992 (476939 MB)
boot device: raid0
root on raid0a dumps on raid0b
root file system type: ffs
  - - 8< - - - - - - - - - - - - - Cut here - - - - - - - - - - - - - >8 - -

-- 
  My other computer also runs NetBSD    /        Sailing at Newbiggin
        http://www.netbsd.org/        /   http://www.newbigginsailingclub.org/